Technical data, Installation, Positioning

Technical data

Closing the door

1.Clean the door gaskets.

2.If necessary, adjust the door. Refer to "Installa- tion".

3.If necessary, replace the defective door gaskets. Contact the Service Center.


Dimension
	Height	1209 mm
	Width	496 mm
	Depth	604 mm
Rising Time		17 h
Voltage		230 V
Frequency		50 Hz

The technical information are situated in the rating plate on the internal left side of the appliance and in the ener- gy label.

Installation

Caution! Read the "Safety Information" carefully for your safety and correct operation of the

appliance before installing the appliance.

Positioning

This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for optimum perform- ance install this appliance at a location where the ambi- ent temperature corresponds to the climate class indi- cated on the rating plate of the appliance:

Climate	Ambient temperature
class
SN	+10°C to + 32°C
N	+16°C to + 32°C
ST	+16°C to + 38°C
T	+16°C to + 43°C

Rear spacers

In the bag with the documentation, there are two spacers which must be fitted as shown in the figure.

1.Fit the spacers into the holes. Make sure that the arrow

(A)is positioned as

	shown in the pic-
	ture.	A
	2. Turn counter-clock-	A
	2. Turn counter-clock-
	wise the spacers	45˚
	through 45° until
	they lock into place.