Replacing the lamp

12	What to do if…


	Problem	Possible cause	Solution

		The door is not closed correctly.	Refer to "Closing the door".

		The door has been opened too	Do not keep the door open lon-
		frequently.	ger than necessary.

		The product temperature is too	Let the product temperature de-
		high.	crease to room temperature be-
			fore storage.

		The room temperature is too	Decrease the room temperature.
		high.

	Water flows on the rear	During the automatic defrost-	This is correct.
	plate of the refrigerator.	ing process, frost defrosts on
		the rear plate.
	Water flows into the re-	The water outlet is clogged.	Clean the water outlet.
	frigerator.

		Products prevent that water	Make sure that products do not
		flows into the water collector.	touch the rear plate.

	Water flows on the	The melting water outlet does	Attach the melting water outlet
	ground.	not flow in the evaporative tray	to the evaporative tray.
		above the compressor.

	The temperature in the ap-	The temperature regulator is	Set a higher temperature.
	pliance is too low.	not set correctly.

	The temperature in the ap-	The temperature regulator is	Set a lower temperature.
	pliance is too high.	not set correctly.

		The door is not closed correctly.	Refer to "Closing the door".

		The product temperature is too	Let the product temperature de-
		high.	crease to room temperature be-
			fore storage.
		Many products are stored at	Store less products at the same
		the same time.	time.

		There is no cold air circulation	Make sure that there is cold air
		in the appliance.	circulation in the appliance.

1.Disconnect the mains plug from the mains socket.

2.Remove the screw from the lamp cover.