When the water system is started for the first time.
The following should be carried out when the appliance is correctly connected to the water supply in the building:
Open the tap on the water connection and start up the refrigerator. The water system main valve opens and the system starts to fill up. Wait for five minutes.
Unpack the filter provided and connect it as follows:
-Remove the filter protective cap and insert the filter connector into the filter seat and turn as shown in the illustration (2) until the filter engages and the projection on the filter cartridge is opposite the mark on the plastic cover. See also the illustration and the instructions on the inside of the service hatch.
-Unlock the water dispenser. See the section "The water dispenser functions" Select carbonated water and drain off about 1.5 litres (2.5 pints) of water. There may be some air to start with.
Connect the gas cylinder provided as follows:
-Take out the gas cylinder from plastic bag and screw the gas cylinder into the adapter (3) for this purpose, which is located in the cabinet, doing this by hand without tools.
-Place the gas cylinder with adapter in the valve and ensure that the valve bracket hooks are under the counterhold on the adapter (5). Then turn up the bracket lever (6) in one continuous movement. See the illustration and the instructions on the inside of the service hatch.
1 | 2 |
3 | 4 |
5 | 6 |
24AEG/Electrolux