Electrolux CHDI 8610 installation instructions Safety warnings, For the User, For the Installer

Page 3

Safety warnings

For the User

The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.

Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames.

Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control.

The hot oil in the frying pan might ignite due to overheating.

The risk of self-ignition increases when the oil being used is dirty.

It is extremely important to note that overheating can cause a fire.

Never carry out any flambé cooking under the hood.

Always disconnect the unit from the power supply before carrying out any work on the hood, including replacing the light bulb (take the cartridge fuse out of the fuse holder or switch off the automatic circuit breaker).

It is very important to clean the hood and replace the filter at the recommended intervals. Failure to do so could cause grease deposits to build up, resulting in a fire hazard.

For the Installer

When used as an extractor unit, the hood must be fitted with a 150mm diameter hose. Should there already be a pipe of diameter 125 mm that ducts to the outside through the walls or roof, it is possible to use the 150/125 mm reduction flange provided. In this case the hood will be slightly noisier.

When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces:

electric cookers

600 mm

gas cookers

650 mm

coal and oil cookers

700 mm min.

The national Standard on fuel-burning systems specifies a maximum depression of 0.04 mbar in such rooms.

The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed.

The air outlet installation must comply with the regulations laid down by the relevant authorities.

When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as the outlet hole.

National and regional building regulations impose a number of restrictions on using hoods and fuel-burning appliances connected to a chimney, such as coal or oil room-

56

Image 3
Contents Chdi Contents Never carry out any flambé cooking under the hood Safety warningsFor the Installer For the UserHeaters and gas fires, in the same room Description of the Appliance Extractor versionRecirculation Version Correct ventilation Hood OperationCharcoal filter LED E Resetting the saturation indicatorControl device for grease and charcoal filters Grease filter LED DRemoving the metal grease Filter Maintenance and careCleaning the hood Metal grease filterFitting Cleaning/replacing the charcoal filter for UKCleaning/replacing the carbon filter not for UK Charcoal filterChanging the light bulb What to do if Symptom SolutionHelp us to help you Special accessoriesTechnical assistance service not for UK Service and spare parts for UKTechnical Specifications Mounting accessories includedDimensions Safety warnings for the electrician Electrical connection not for UKElectrical connection for UK only Fix the two sections of the structure using 8 screws Installation Fig273 244 190 14,5 214 Page 13F 13A Page LI1R5C

CHDI 8610, DI 8610 specifications

The Electrolux DI 8610, also known as the CHDI 8610, is a cutting-edge dishwasher that embodies convenience, efficiency, and innovative design. This appliance is engineered to meet the demands of modern households that seek both performance and reliability in their kitchen.

One of the standout features of the Electrolux DI 8610 is its advanced wash system. It utilizes a high-efficiency spray arm design, ensuring that water reaches every corner of your dishes, pots, and pans. This results in a superior clean, effectively removing baked-on food residues without requiring pre-soaking or excessive scrubbing.

The DI 8610 is equipped with multiple wash programs, ranging from intensive cycles for heavily soiled cookware to delicate settings for fragile glassware. One of its most notable options is the 'Auto' mode, which automatically adjusts the cycle based on the load's soil level, optimizing water and energy consumption for improved efficiency.

In terms of capacity, the Electrolux DI 8610 is designed with flexibility in mind. The adjustable racks and foldable tines allow for easy arrangement of various dish sizes, making it simpler to load everything from large baking trays to small espresso cups. This flexibility ensures that users can maximize the available space, accommodating different washing needs with ease.

Sound levels are a critical concern for many homeowners, and the DI 8610 addresses this with its quiet operation technology. With a noise level of around 44 decibels, it operates almost silently, allowing users to run cycles even during late-night hours without disruption.

Energy efficiency is another hallmark of the Electrolux DI 8610. Built to meet stringent energy standards, this dishwasher minimizes water and energy consumption without compromising cleaning performance. This eco-friendly design not only benefits the environment but also leads to reduced utility bills over time.

Lastly, the design aesthetic of the DI 8610 is sleek and modern, seamlessly integrating into any kitchen décor. Its intuitive control panel is user-friendly, featuring a digital display that allows for easy selection of wash cycles and options.

In conclusion, the Electrolux DI 8610, or CHDI 8610, combines powerful cleaning performance with innovative features and eco-friendly design, making it a stellar choice for those looking to enhance their dishwashing experience.