Installation Instructions

Safety instructions

The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc.)

Installation may only be carried out by a qualified electrician.

The minimum distances to other appliances and units are to be observed. Anti-shock protection must be provided by the installation, for example drawers may only be installed with a protective floor directly underneath the appliance.

The cut surfaces of the worktop are to be protected against moisture using a suitable sealant.

The sealant seals the appliance to the work top with no gap.

When building in, protect the underside of the appliance from steam and moisture, e.g. from a dishwasher or oven.

Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened.

1 WARNING!

Risk of injury from electrical current.

•The electrical mains terminal is live.

•Observe connection schematic.

•Observe electrical safety rules.

•Ensure anti-shock protection through correct installation by a qualified electrician.

•The appliance must be connected to the electrical supply by a qualified electrician.

1IMPORTANT!

Risk of injury from electrical current.

Loose and inappropriate plug and socket connections can make the termi- nal overheat.

•Have the clamping joints correctly installed by a qualified electrician.

•Use strain relief clamp on cable.

•In the event of single-phase or two-phase connection, the appropriate mains cable of type H05BB-F Tmax 90° (or higher) must be used.

•If this appliance’s mains cable is damaged, it must be replaced by a spe- cial cable (type H05BB-F Tmax 90°; or higher). The latter is available from the Customer Care Department.