Hob installation

. Cut out the worktop according to the cutout size. The tolerances must not be exceeded. Precisely saw at the marked.

. With tile--coated worktop areas any slits in the surface of the cooking area must be filled up com- pletely.

. Clean the worktop in the cutout area

. The hob is fitted from the top into the cut--out sec- tion, centered and firmly pressed on until the springs will catch.

. Check the sealing in the supporting frame for per- fect seating and resting without a gap. Please do not apply additional silicone sealing material. It will make it harder to dismantle in case of ser- vice.

. 5 holes in the bottom of the build--in case are pro- vided for the screws of the fitting plates.

. At first screw on the fitting plates with a screw- driver and afterwards tighten the plates alterna- tively and diagonally, until the frame of the cook- ing area is perfectly laying on the worktop.

. Over--tightening must be avoided! Electric screw- drivers are to be exclusively used with slip clutch (setting value 1 -- 1.1 Nm).

ceramic glass plate	frame
ceramic glass plate
	worktop

fixing clamp