Operation
Hob burners
)To light a burner:
z turn the relevant control knob anticlockwise to the maximum position, then push it down to ignite the burner;
z upon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" (Fig. 1, D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted.
z then, check the flame is regular and adjust it as required.
If you cannot light the flame even after several attempts, check the "cap" and “crown” (Fig. 1,
To put the flame out, turn the knob to the symbol z.
When switching on the mains, after installation or
a power cut, it is quite normal for the spark generator to be activated automatically.
To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).
Burner | minimum | maximum |
| diameter | diameter |
|
|
|
|
| |
180 mm | 260 mm | |
Large (rapid) | 180 mm | 260 mm |
Medium | 120 mm | 220 mm |
Small (auxiliary) | 80 mm | 160 mm |
If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.
Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.
As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.
If the control knobs become difficult to turn, please contact your local Electrolux Service Force Centre.
| |
A |
|
B |
|
D |
|
C |
|
A - Burner cap | Fig. 1 |
B - Burner crown |
|
C - Ignition electrode |
|
D - Thermocouple |
|
4