Electrolux 61502 G operating instructions Cut Out Size, Building over a cupboard or drawer

Page 17

Cut Out Size

The dimensions of the cut-out are given in the diagram.

500

580

470

550

FO 2109

Building In

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2.

Image 17

Contents

61502 G Installation Important Safety InformationChild Safety During UseEnvironmental Information ServiceContents 7 6 Description of the HobHob burners control knobs OperationBurner Minimum Maximum Diameter Hob Top Maintenance and CleaningPan Supports BurnersSomething Not Working? Symptom Solution0870 5 929 Service and Spare PartsCustomer Care Standard guarantee conditions Guarantee ConditionsEuropean Guarantee ExclusionsEngineer technical data Instructions for the Installer Type of GAS Location Important safety requirementsInstallation Gas Connection Building over a cupboard or drawer Cut Out SizeBuilding Building over a kitchen unit with door Fitting the hob to the worktop SealThis HOB Must be Earthed Electrical connectionsPermanent Connection Wiring diagramPreliminary Electrical Systems Check Fault FindingEarth Continuity Check Check gas supply at burner Ignition System / Gas IgnitionCommissioning Pressure TestingMethod Conversion from Natural Gas to LPGPage AEG Hausgeräte GmbH Postfach 90327 Nürnberg Electrolux plc