Mounting

Caution: In order to avoid a hazard this appliance must be installed according to these instructions for installation

The appliance unit can be mounted	in
any type of kitchen with a work top
whose thickness is between 28 mm and
40 mm.	mm
	Min. 47

Clearance

The distance between the top side of the work top and the carpentry underneath must be at least 47 mm.

Stainless steel surfaces

Clean the appliance after use with a soft cloth well wrung out in warm water, use a small amount of liquid detergent for stubborn soiling. Stainless steel parts may become straw coloured with use, use a proprietary stainless steel cleaner to remove this straw discolouration.

Never use metal wool, metal sponges or other abrasive cleaning agents.

The ceramic glass hob

3.Wipe the ceramic hob clean with a damp cloth or kitchen roll. Tough stains can be removed by rubbing the stain hard with kitchen roll.

4.Wipe off remaining cleaning agent with a damp cloth.

5.Wipe with a dry cloth, if required.

Make sure that the ceramic hob is dry when you heat it up again. Ceramic hobs can develop rainbow-like stripes if heated while damp.

Fixing

Screw the fixing brackets out to such an extent that they can be turned in under the work top. Tighten the brackets on to the work top with an ordinary screwdriver.

Cut-out measurements

One rectangular hole is sawn out for the appliance combination chosen.

The depth of the cut-out for any unit is: 490 mm

Length of hole = sum of all units` externally measured length, less 20 mm.

Mounting of Reinforcement Beams

A reinforcement Beam, with supporting flanges at each end, is included with each two-burner unit. For unit combinations, a reinforcement beam must be used between each unit.

Minimum distance	Minimum distance
to wall:	to wall (non-
150 mm	flammable material):
	150 mm

Reinforcement beams

Immediately scrape off stains caused by food which has boiled over using the scraper supplied with the hob, spilled sugar, dishes containing sugar (jam, juice, etc.), melted plastic and aluminium foil while the ceramic hob is still hot. If the ceramic hob is allowed to cool it may become damaged. A dirty ceramic hob decreases the heat transfer between cooking zones and cookware.

After use the cooking zones should be wiped with a damp cloth with washing up liquid. For severe soiling you can follow these steps:

1.Remove stains etc., with the ceramic hob scraper.

2.Make sure that the ceramic hob has cooled down. Use a ceramic cleaning agent, such as vitroclen.