16 electrolux GB
10.Insert again the BRITA MAXTRA cartridge in the funnel as described in section "How to change the BRITA MAXTRA cartridge".
How to use the BRITA MAXTRA filter cartridge
STEP 1: PREPARING THE
CARTRIDGE
To prepare your BRITA filter cartridge, please remove protective wrapper (note: cartridge and inside wrapper may
appear moist, this is simply condensation). Immerse cartridge in cold water and shake it gently to remove any air bubbles. The filter now is ready to use. As required for other water filter cartridges, there is no need to
STEP 2: INSERT IN THE WATER TANK
Remove the tank lid. Before inserting the cartridge, remove the funnel and
clean it thoroughly by rising it and wiping it dry. Then thoroughly clean the inside of the water tank with a damp cloth and wipe it dry as well. Place the cartridge into the filter tank and push downwards until it 'clicks' firmly into place. The cartridge should stay in place if the funnel is turned upside down.
STEP 3: RINSE CARTRIDGE
Take the funnel out of the BRITA water filter unit, fill it under the tap with cold tap water and allow it to filter through. Discard the first two fillings into the sink. These first two fillings are used to flush the filter cartridge.
Then place the funnel back into BRITA water filter unit.
Place the cover back onto the jag and press it carefully downwards to ensure it fits correctly into place.
STEP 4: REFILL WATER TANK
To fill the tank with cold water, simply open the flip top lid, take a jug of tap water and pour it inside the tank through the cover as shown into the picture (use the lid every time that you want to filter your water).
Important!
In order to avoid risk of spillage of water during closing and opening of the