Electrolux Electronic Freezer no_frost manual Control Panel, Temperature setting buttons

Page 16

Description of the appliance

Control Panel

1ON/OFF button and ON/OFF indicator light (green)

2Temperature display

3Temperature setting buttons

4TURBO/FROSTMATIC button and TURBO/FROSTMATIC indicator light (yellow)

5ALARM OFF button and warning indicator light (red) (see section: "Control and Information Systems")

Temperature setting buttons

The temperature is adjusted using the „+“ (WARMER) and „-“ (COLDER) buttons.

These buttons are connected to the temperature display.

•The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the dis- play of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, „+“ (WARMER) or „-“ (COLDER).

•Each time one of the two buttons is pressed again the DESIRED tem- perature is adjusted by 1 °C.

•If neither button is pressed, the temperature display automatically switches back after a short period (approx. 5 sec.) to the display of the ACTUAL temperature. The ACTUAL temperature in the appliance is now adjusted to match the preset DESIRED temperature.

DESIRED temperature means:

The temperature that is required in the appliance, this can be adjusted to the temperatures shown in the display. The DESIRED temperature is indicated by flashing numbers.

ACTUAL temperature means:

The temperature display indicates the temperature that is currently present in the appliance. The ACTUAL temperature is indicated with illuminated numbers.

3 Once the TURBO/FROSTMATIC function has been switched on the DESIRED temperature that was set originally cannot be changed.

16	818 22 86-00/8

Image 16

Contents Arctis Dear customer Contents Cooling drinks What to do ifImportant Safety Instructions Prior to InstallationInstallation RefrigerantChild Safety Maintenance and CleaningDuring Use ServicingWhen disposing of your old appliance Environmental InformationAppliance Transport PackagingInstallation Location InstallationBefore Use Installation Freezer needs ventilationAppliance Alignment Electrical Connection Reversing the door Plinth cover from the left to the right. Close the door Move the upper hinge bracket pivot to the left No-frost frost free system View of the appliance Description of the applianceCold accumulation block These buttons are connected to the temperature display Temperature setting buttonsControl Panel Temperature display Alarm OFF button TURBO/FROSTMATIC-buttonInitial use Prior to Initial Start-UpRemove the cold accumulation block from the appliance Temperature Adjustment Select Freezing or CoolingSwitching the Appliance Off Temperature Warning Red warning indicator will go out when the door is closedControl and Information Systems Open Door WarningFunction Errors Temperature memoryOpening the door Only in the operating mode Freezing FreezingPreparation of Ice Cubes Frozen StorageTips Storage Goods Symbols/Freezing Calendar Maximum LoadCooling Long Fresh CoolingStandard Cooling Cooling drinksEnergy Saving Advice Hints and TipsNormal Operating Sounds Food StorageMaintenance and Cleaning Internal CleaningExternal Cleaning Regulations, Standards, GuidelinesWhat to do if Correcting MalfunctionsWhat to do if Replacing the light bulb Replace defective light bulb Place the cover againTechnical Terminology Refrigerant CircuitEvaporator CompressorGuarantee Conditions Standard Guarantee ConditionsService & Spare Parts 08705 929Customer Care Calls may be recorded for training purposesSubject to change without notice