40electrolux
Rear spacers
In the bag with the documentation, there are two spacers which must be fitted as shown in the figure .
Slacken the screws and insert the spacer under the screw head, then re- tighten the screws.
PR153 |
Door reversibility
Before carrying out any operations, remove the plug from the power socket.
To change the opening direction of the door, proceed as follows:
•To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the door of the appliance during the operations.
•Open the door with the appliance in the upright position. Unscrew the screws and remove the upper door plastic trim.
•Remove the little plastic cover from the door plastic trim and refit on the opposite side (d).
•Lay down the appliance back side down.
•Remove the screw of the hinge cover plug (a).
•Unscrew the upper hinge and remove it (b).
•Unscrew the screw and remove the door stopper (c).
b |
c |
a |
•Remove the door.
•Remove using a tool the cover (e) unscrew the lower hinge pivot (f) and place it on the opposite side.
•Reinsert the cover (e) on the opposite side.
•Reinsert the door .
•Pay attention that the front board of the door is parallel to the front board of the top.