Electrolux E39WD75GTT Oven Cutout, Electric Single, High-Speed Ovens Specifications

Page 3

High-Speed Oven/Electric Single Wall Oven/ Warmer Drawer Combination Installation

For detailed product dimensions and installation specifications, refer to model-specific product page and installation guide on web

E30SO75FPS

 

 

 

E30SO75ESS

21 11/16"min.

High-Speed

223/16"max.

Oven Cutout

2"

 

 

 

 

 

 

 

 

(visible

 

gap)*

E30EW75GPS

 

 

 

 

 

 

E30EW75GSS

 

 

 

Electric Single

28 1/2"min.

Wall Oven Cutout

28 7/8"max.

 

E30WD75GPS

 

 

 

13/4"min.

E30WD75GSS

 

 

 

E30WD75GTT

9 7/8"min.

Warmer Drawer

Cutout

10 1/4"max.

 

41/2"min.

 

 

 

 

 

 

 

 

required

 

 

 

 

 

 

24" min. 30"min.

20 1/4"

16 3/4"

22 3/8" min.

 

22 7/8" max.

C

 

L

28 1/2"min.

24" min.**

(critical

29" max.

dimension)

28 1/2"min.

29" max.

240V/60 Hz grounded electrical outlet should NOT be located within shaded area

Full plywood base required to support 150 lbs.

Two 3" wide by 3/4" thick planks must be installed, capable of supporting 200 lbs.

Bottom of

oven cutout

11 5/8"min.**

(critical

dimension)

3"max.

††

 

*Minimum 2 5/8" clearance required from bottom of Built-In High-Speed Oven cutout to top edge of Wall Oven’s faceplate, leaving a 2"visible gap between both product faceplates

**Critical dimension – MUST be applied

Maximum height depends on critical dimension (11 5/8")

††Electrical junction box for Wall Oven must be lower than the Warmer Drawer cutout

Full plywood base

Electrical junction

required to support

box location

100 lbs.

4"x 4" opening to route

 

armoured cable

High-Speed Oven / Electric Single Wall Oven / Warmer Drawer Combination Installation Specifications

Always consult local and/or national electric codes.

(Refer to product-specific electrical specifications on this page.)

Minimum 24"deep cutout dimension is critical for proper combination installation, to ensure that each built-in product’s faceplate will fit flush against cabinet front.

Bases must be level and cabinet front must be square.

Minimum 4-1/2"required distance from bottom of Warmer Drawer cutout to floor.

Respect critical dimensions as noted for proper installation of built-In products.

Minimum 23-1/4" clearance needed for Wall Oven door depth when open.

30" High-Speed Ovens Specifications

Product Weights – (E30SO75FPS/E30SO75ESS) 115 Lbs.

Voltage Rating – 240V/60 Hz/15 or 20 Amps

Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

Connected Load (kW Rating) @ 240 Volts = 3.3kW

Amps @ 240 Volts =13.2 Amps

Full base of solid plywood or similar material required, capable of supporting 150 Lbs.

Minimum 2-5/8"clearance required from bottom of High-Speed Oven cutout to top edge of Wall Oven’s faceplate, leaving a 2"visible gap between both product faceplates.

30" Electric Single Wall Ovens Specifications

Product Weights – (E30EW75GPS) 178 Lbs. / (E30EW75GSS) 175 Lbs.

Single phase 3- or 4-wire cable, 120/240 or 120/208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

Connected Load (kW Rating) @ 240/208 Volts = 4.0/3.0kW

Amps @ 240/208 Volts =16.6/14.4 Amps

To support Wall Oven, two 3"-wide x 3/4" thick planks must be installed as a base, capable of supporting 200 Lbs. Do NOT use full base, since planks are necessary to allow for proper air displacement.

30" Warmer Drawers Specifications

Product Weights – (E30WD75GPS/E30WD75GSS) 49 Lbs. / (E30WD75GTT) 41 Lbs.

Voltage Rating – 120V/450W/60Hz/15 Amps

Connected Load (kW Rating) @120 Volts = 0.45kW

(For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

Amps @120V = 3.75 Amps

Full base of solid plywood or similar material required, capable of supporting 100 Lbs.

Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxicon.com for detailed instructions.

USA 250 Bobby Jones Expressway Augusta, GA 30907 1-877-4electrolux (1-877-435-3287) electroluxicon.com

High standards of quality at Electrolux Home Products, Inc. mean we are

constantly working to improve our products. We reserve the right to change

CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4 1-800-265-8352 electroluxicon.ca

specifications or discontinue models without notice.

SO_EW_WD INST 03/08

© 2008 Electrolux Home Products, Inc.

Printed in the U.S.A.

Image 3
Contents Stainless Steel Interior Design Flexible Temperature ControlPanel Ready Smooth-GlideFull-Extension Warmer DrawerWarmer Drawer/Wall Oven Combination Specifications Panel-Ready Warmer Drawer SpecificationsCustom Panel Specifications Optional AccessoriesHigh-Speed High-Speed Ovens SpecificationsElectric Single Wall Ovens Specifications Warmer Drawers SpecificationsBuilt-In Convection Microwave Specifications 41/2min Required 24 min28 1/2min 29max 29 max 30 min