8 TROUBLESHOOTING
CONTINUED FROM PAGE 7 |
|
|
|
|
|
Symptom |
| Possible Cause |
| Corrective Action | |
|
| ||||
|
|
|
|
|
|
Furnace/Air Conditioner Cycles Too Fast or |
| 1. | The location of the thermostat and/or the |
| Digital thermostats normally provide precise |
Too Slow (narrow or wide temperature swing) |
|
| size of the Heating/Cooling System may be |
| temperature control and may cycle faster than |
|
|
| influencing the cycle rate. |
| some older mechanical models. A faster cycle |
|
|
|
|
| rate means the unit turns on and off more |
|
|
|
|
| frequently but runs for a shorter time so there is |
|
|
|
|
| no increase in energy use. If you would like to |
|
|
|
|
| increase the cycle time, refer to step 3 on the |
|
|
|
|
| Configuration Menu |
|
|
|
|
|
|
Thermostat Setting and Thermostat |
| 1. | Thermostat thermometer setting requires |
| The thermometer can be adjusted +/- 3 degrees. |
Thermometer Disagree |
|
| adjustment. |
| See Temperature Display Adjustment in the |
|
|
|
|
| Operation section. |
|
|
|
|
|
|
Blank Display and/or Keypad Not |
| 1. | Voltage spike or static discharge. |
| Use the Reset Operation listed above. |
Responding |
|
|
|
|
|
|
|
|
|
|
|
Heat Setpoint Will Not Respond |
| 1. | The desired setpoint conflicts with the |
| Change system mode to COOL. Raise the Cool |
to the Temperature Up Key |
|
| setpoint of the COOL mode. |
| setpoint. Return to HEAT mode and set desired |
|
|
|
|
| temperature. |
|
|
|
|
|
|
Cool Setpoint Will Not Respond |
| 1. | The desired setpoint conflicts with the |
| Change system mode to HEAT. Lower the Heat |
to the Temperature Down Key |
|
| setpoint of the HEAT mode. |
| setpoint. Return to COOL mode and set desired |
|
|
|
|
| temperature. |
|
|
|
|
|
|
The Emerson logo is a trademark and a service mark of Emerson Electric Co.