Viking F20533 EN manual Leveling/Adjustments/Alignments Anti-tip Device Installation

Leveling/Adjustments/Alignments (cont.)

7

Anti-tip Device Installation (cont.)

3 4

Set the high corner of range so that the top of side trim is 3/8” (0.95 cm) above countertop. Level range to high corner.

Mark and drill holes where bracket will be located.	Attach bracket with
	mounting hardware provided.

Anti-tip Device Installation

WARNING

Tipping hazard.

To reduce the risk of property damage or personal injury; install anti-tipping device provided in accordance with the installation instructions in this document. Device must be engaged properly to prevent product from tipping over.

1

Measure

ment(A )

Measure from floor to bottom

of the anti-tip opening located on the back of range.

This will be measurement (A).

Connecting Gas & Electric

DANGER

Gas leak hazard.

To avoid risk of personal injury or death; leak testing of the appliance must be conducted

according to the manufacturer’s instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution.

• DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.

Note: Refer to electrical and gas requirements section for proper installation information.

2

X

									nt	(A	)
								e
							m			)
					e			.3	cm
	ea		sur			(1
M				2	”
	+	1/

Locate anti-tip bracket on rear wall with the top left corner at

measurement (A) plus 1/2” (1.3 cm) from the floor and 3-5/8” (9.2 cm) from where the right side of range (facing range) is to be located.

Range	“X”
Width	Dimension
30”	3-5/8” (9.2 cm)
36”	8” (20.3 cm)
48”	5” (12.7 cm)
60”	5” (12.7 cm)

Anti-tip location for each range width.

1

Connect gas and electrical.Before placing appliance in operation, always check for gas leaks. This must be performed by your dealer,a qualified licensed plumber,or gas service company.

22 23