Replacing Interior Oven Lights, Power Failure

Replacing Interior Oven Lights

CAUTION: DISCONNECT THE ELECTRIC POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BEFORE REPLACING BULB.

1.Unscrew glass light cover.

2.Use an oven mitt during bulb removal to protect your hand in case the bulb breaks.

3.Replace the bulb with a 120 volt, 40-watt appliance bulb.

4.Replace the light cover

5.Reconnect power at the main fuse or circuit breaker.

Power Failure

Since this oven uses electronic ignition, electrical power failure in the home will affect the oven. During a power failure, electric igniters will not work and the oven cannot be used. Momentary power failures can occur unnoticed. The oven is affected only when the power is interrupted. When power is restored, the oven will be fully useable. A “brown-out” may or may not affect the oven’s operation, depending upon the severity of the power loss. If power loss or brown-out is suspected, do not use the oven until electrical service is restored.

Service Information

If service is required after checking the troubleshooting guide:

1.Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area.

2.Have the following information readily available: Model Number

Serial Number Date of Purchase

Name of dealer from whom purchased

3.Clearly describe the problem that you are having.

If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range Corporation at (662) 451-4133 or write to:

VIKING RANGE CORPORATION

PREFERRED SERVICE

111 Front Street

Greenwood, Mississippi (MS) 38930 USA

Record the following information indicated below. You will need it if service is ever required. The serial number and model number for your oven is located behind the lower access panel.


Model Number						Serial Number
Date of Purchase						Date Installed
Dealer’s Name
Address

Please retain the manual for future reference