Product Care
Cleaning and Maintenance
Glass Shelves
To clean your refrigerator's glass shelves, lift the shelf out by lifting the front and releasing the hooks from the metal track. Then pull the shelf out. Be sure to allow the glass shelves to adjust to room temperature before cleaning.
To clean crevices, dilute mild detergent with water. Brush this solution into crevices using a plastic bristle brush. Let set for five minutes. Spray warm water into crevices using faucet spray attachment. Dry glass shelf thoroughly and replace shelf by inserting hooks into metal track and lowering front.
Door Gaskets
Clean the door gaskets every three months using the same procedures used for interior surfaces. You should apply a light film of petroleum jelly to keep gaskets pliable.
CAUTION
Toavoid personalinjuryor propertydamage,handletemperedglass shelvescarefully.Shelvesmay breaksuddenlyif nicked,scratched,or exposedto suddentemperaturechanges.
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power or turn power disconnect switch to OFF position before removing top grille. Failure to do so can result in death or electrical shock.
WARNING
BURN HAZARD
Do not touch condenser coils near defrost pan.
Doing so can result in burns.
Cleaning and Maintenance
Defrost Pan
To prevent condensation from overflowing, check defrost pan periodically.
To check defrost pan, remove two screws securing kickplate to unit. Pull defrost pan forward until it stops. Remove any excess water from pan. Wipe and clean defrost pan with a sponge. Return defrost pan to original position. Return kickplate to unit by securing with two screws.
Door Stop Adjustment
Your refrigerator is factory set at the 110° door stop position. To change to either the 90° or 120° position, remove the door stop pin using a 3/16” allen wrench.
1
1
3
2
Open refrigerator door so door stop and
shoulder screw are accessible.
2
1
90˚
110˚
120˚
2
Remove shoulder screw and place in 90° or
120° position.
Product Care
34 | 35 |