Viking F20872 manual General Information, Remove the Packaging, When moving your refrigerator

Page 6

Proper Disposal (of old refrigerator)

General Information

IMPORTANT:

Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous - even if they will sit for “just a few days.” If you are getting rid of your old refrigerator, please follow these instructions to help avoid accidents.

Before You Throw Away Your Old Refrigerator or Freezer:

Take off the doors.

Leave the shelves in place so that children may not easily climb inside.

Your refrigerator was packed carefully for shipment. Remove and discard all packaging and tape. DO NOT remove the model/serial number label.

Remove the Packaging

Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

DO NOT use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see “Refrigerator Safety.”

Dispose of/recycle all packaging materials.

When moving your refrigerator:

Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. DO NOT wiggle or “walk” the refrigerator when trying to move, as floor damage could occur.

Clean Before Using

After you remove all of the packaging materials, clean the inside of your refrigerator before using

it. See the cleaning instructions in “Use and Care Guide.”

Important information to know about glass shelves and covers:

DO NOT clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use special care when removing them to avoid impact from dropping.

Location Requirements

DO NOT install refrigerator near oven, radiator or other heat sources. If not possible, shield refrigerator material.

DO NOT install where the temperature falls below 55°F (13°C) or rises above 110°F (43°C). Malfunctions can occur at these temperatures.

Refrigerator is designed for indoor household application only.

10

11

Image 6
Contents Viking Installation Guide Table of Contents Refrigerator Safety Specifications Professional Professional French Door Bottom-MountDimensions Professional with Grille/Side Panels/Top General Information When moving your refrigeratorClean Before Using Remove the PackagingElectrical Requirements Water Supply RequirementsMoving Unit Doors & Drawer Removal Door & Drawer Removal Connect to Water Line InstallationConnect the Water Supply Connect to RefrigeratorLeveling/Adjusting the Door Complete the InstallationFinal Steps Performance Checklist Service & Registration