Viking Combination Beverage Center manual Arm down, ice maker will operate Arm up stops operation

Page 12

Setting the Controls

The temperature control knob is located in the grille below the door. There is a pointer on the grille at the 12:00 position to indicate knob position. The “OFF” position will turn the refrigeration system off. Position 1 is the warmest setting and position 7 is the coldest. Wait at least 2 hours between temperature adjustments to find a

temperature that suits you.

The refrigerator section temperature of the unit can be adjusted using the adjusting slide located in the left side and rear of the refrigeration section. Turn in the cold direction indicted to make the refrigeration section colder and the opposite to warm the refrigeration section.

FOR OUTDOOR UNITS - it is recommended that in temperatures above 110oF(43oC) and below 45oF (7.2oC) the unit be shut off. The normal operating range for the unit is between 60oF (15.6oC) and 100oF (37.7oC).

Defrosting

This unit uses an electronic control system to control both defrost and refrigeration functions. This feature eliminates the inconvenience of manual defrosting of the evaporator in normal conditions. If commodities or ice accidentally clog the drip tray, the obstruction must be removed for proper defrost performance. It is normal fro some water droplets to be left on the evaporator or drip tray. These will refreeze and be removed in the next defrost cycle.

Defrosting is factory set to run after the compressor has run approximately 12 hours. For climates with high humidity levels and/or repeated opening of the door, an optional 6-hour compressor run time is already programmed into the control. A switch will have to be set at the control for this change to take place. (Consult your dealer or authorized service center).

A drip tray heater is located in the unit for proper removal of condensation. The heater will remain on as long as the unit is plugged in. The control knob will not turn the heater off. Unplug or disconnect power to the unit if you are planning to leave the unit off or unattended for extended periods of time.

Ice Maker Operation

•Make certain water pressure is at least 20 psi and no more than 120 psi and is turned on.

•The unit must be installed level for proper icemaking operation. •The bale arm must be down in its lowest position for the icemaker to operate.

•Make certain there are no obstructions in the fan inlet and outlet. The fan is located beside the ice maker at the top of the freezer section. •When the freezer section and ice maker unit has sufficiently cooled, the ice maker will harvest ice cubes automatically.

•When the ice bucket is full, the ice maker will automatically shut off. •You may manually stop the ice maker by raising the bale arm to the locking position at the up most position.

Arm down, ice maker will operate

Arm up stops operation

IMPORTANT: When operation of the appliance is to be discontinued for any length of time or if temperatures are below 450F (7.20C) for outdoor units, the ice cube cavity in the ice maker should be emptied and dried. The water supply and power supply should also be shut off and the ice bucket should be emptied and cleaned. If the ice is not used regularly, it will clump together with time. For best results, discard ice in the bin as required and allow the ice maker to make a new fresh batch of ice.

12

Image 12
Contents Viking Use/Installation Guide For Your Safety Important Please Read and FollowProper Disposal of Your OLD Refrigeration Product SPECIFICATIONS/DIMENSIONS Professional Series Undercounter Cabinet Cutout24 61.0 cm Min 1/2 87.6 cm Max 1/8 89.2 cm SPECIFICATIONS/DIMENSIONS LEG Leveler Installation General InformationArea Requirements Full Overlay Panel Installation Selecting and Preparing the Overlay Panel For a 3-1/2 TOE Kick29 13/16 Hinge Hardware Installation Details Attaching the Overlay Panel to the DoorElectrical Connection Water ConnectionFinal Preparation Grounding Instructions Operating InstructionsArm down, ice maker will operate Arm up stops operation Preparing the unit for storage Interior LightLight Bulb Replacement Cleaning and MaintenanceTroubleshooting Chart Problem Possible Cause SolutionDiagnostic LED LED Status Code/ProblemService Information Viking Preferred ServiceUnits certified for Outdoor Use Units certified for Indoor Use PS0806VR

Combination Beverage Center specifications

The Viking Combination Beverage Center is an innovative appliance that perfectly merges style, functionality, and advanced technology, making it an ideal addition to any modern kitchen or entertainment space. Offering a versatile way to store and display beverages, this combination beverage center is engineered to meet the needs of both casual hosts and serious entertainers.

One of the key features of the Viking Combination Beverage Center is its dual-zone design. This allows users to maintain different temperature settings for various beverages, ensuring that wines, soft drinks, and other refreshments are kept at their optimal serving temperatures. The upper zone typically caters to wine, while the lower zone is perfect for other bottles and cans, helping to preserve the unique flavors and characteristics of each beverage.

In terms of storage, the Viking Beverage Center is designed with flexibility in mind. Its adjustable shelving, usually made of robust glass, allows for easy organization of both tall and short bottles, while the dynamic cooling system ensures that every beverage is chilled uniformly. Some models even include a distinctive Wine Rack, which can safely hold wine bottles horizontally, preventing cork drying and maintaining freshness.

Not only does the Viking Combination Beverage Center boast impressive performance features, but it also includes a range of sophisticated technologies designed for user convenience. The precise digital temperature control allows for easy adjustments with a simple touch, while LED lighting illuminates the interior beautifully, making it easy to browse selections, even in dim light. The Low-E glass door helps to insulate the interior while showcasing the beverages inside, providing energy efficiency alongside aesthetic appeal.

Moreover, the appliance is equipped with a fan that circulates air at consistent temperatures, preventing hot spots and ensuring that beverages are chilled evenly. The moisture control feature helps sustain a balanced humidity level, promoting the longevity of stored products, particularly for wines.

The Viking Combination Beverage Center is available in various sizes and finishes, allowing it to seamlessly blend with a plethora of kitchen decors. Its sleek design, coupled with high-quality stainless steel construction, makes it a standout piece that adds a touch of elegance to any environment.

In conclusion, the Viking Combination Beverage Center is a perfect blend of style, practicality, and advanced technology. With its dual-zone temperature control, flexible shelving, and user-friendly features, it is the ultimate solution for those who wish to keep their beverages at the perfect temperature while making a statement in their space.