INSTALLATION I N S T R U C T I O N S
HOOD P R E PA R AT I O N
Follow these steps to prepare the wall chimney hood for installation:
Remove the filters by pressing up at the angle the filters are placed in, then rotate the bottom of the filter down. Gloves should be worn to provide proper grip.
Slide the grease cups out from the bottom edges of the back of the hood.
Using a Phillips screwdriver, remove the screws retaining the internal frame (shaded area of the illustration below) to the hood.
Be careful not to remove the two other
screws (refer to the illustration below). Do not discard the screws. They will be reinstalled after installation of the hood is complete.
Remove the internal frame from the hood and set aside.
The hood assembly is shipped with the transition attached. The transition is shipped upside down in the top of the hood and must be removed and reinstalled in the proper position.
Separate the transition from the hood assembly by removing the four shipping screws. Invert and reattach the transition to the hood with the shipping screws.
IMPORTANT NOTE: If internal blower Model
If you are installing a remote blower, punch out the knockout hole located on the top of the hood. Install a wire clamp (included with the hood) for remote blower cable. Refer to the remote blower information on page 16 and follow installation instructions provided with the blower assembly.
Install one wire clamp (included with the hood) in the hole on top of the hood for the power cable.
Do not run wiring for the remote blower through the ductwork.
Spring |
|
Filter |
|
| Grease |
SIDE VIEW | Cup |
Remove filters
Do not | Internal frame screws location | Do not |
remove | remove |
Remove internal frame
Dimensions in parentheses are in |
|
millimeters unless otherwise specified. | 9 |