Electrical Requirements
General Information
Electrical Requirements
Check your local codes regarding this unit. This cooktop is supplied with a
Refer to the specifications chart and the identification label on the bottom of the burner box for kilowatt rating and recommended amperage. House wiring and fusing must comply with local codes. If no local codes are applicable, wire in accordance with the National Electrical Code,
Electrical Connection
WARNING
The electrical power to the unit must be shut off while line
connections are being made. Failure to do so could result
in serious injury or death.
When making the wire connections, use the entire length of the conduit provided (3 feet). The conduit must not be cut.
Connect the red and black leads from the unit conduit to the corresponding leads in the junction box. The bare ground wire in the conduit is connected to the unit frame. When connecting to a
READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE.
•All openings in the wall behind the appliance in the floor under the appliance shall be sealed
•Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors.
•Disconnect the electrical supply prior to servicing or cleaning.
•When removing the cooktop for service and/or cleaning, disconnect AC power supply.
•Electrical requirements are listed in the product specifications under the “Electrical Requirements” section.
WARNING
ELECTRICAL
GROUNDING
INSTRUCTIONS
This cooktop must be electrically grounded in accordance with local codes or, in the absence of codes, with the National Electrical Code,
–latest edition. FOR PERSONAL
SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.
WARNING
This appliance shall not be used for space heating. This information is based on safety considerations.
WARNING
FIRE AND ELECTRICAL SHOCK HAZARD
DO NOT use an extension cord with this appliance. Such use may result in fire, electrical shock, or other personal injury.
CAUTION
Be sure the electric power is off from the breaker box to the
junction box until the cooktop is installed and ready to
operate. The junction box should be connected to a suitable ground. DO NOT use aGFI circuit.
10 | 11 |