Clearance Dimensions (Proximity to Cabinets)
Clearance Dimensions (Wood/Composite Overlay)
Proximity to Side Cabinet Installation
• | The cooktop may be installed directly to |
| existing base cabinets. |
• | The cooktop CANNOT be installed |
| directly adjacent to sidewalls, tall cabinets, |
| tall appliances, or other side vertical |
| surfaces above 36” (91.4 cm) high. There |
| must be a minimum of 6” (15.2 cm) side |
| clearance from the cooktop to such |
| combustible surfaces above the |
| 36” (91.4 cm) counter height. |
• | Within the 6” (15.2 cm) side clearance to |
| combustible vertical surfaces above |
| 36” (91.4 cm), the maximum wall cabinet |
| depth must be 13” (33.0 cm) and wall |
| cabinets within this 6” (15.2 cm) side |
| clearance must be 18” (45.7 cm) above |
| the 36” (91.4 cm) high countertop. |
Minimum Clearances from Adjacent Combustible Construction
•Above countertop 36” (91.4 cm) minimum
•Side 6” (15.2 cm)
•Rear 0” (0.0 cm)
•Within 6” side clearance. Wall cabinets no deeper than 13” (33.0 cm)
•Must be minimum 18” (45.7 cm) above countertop
•Wall cabinets directly above the product must be minimum 36” (91.4 cm) above the countertop
The bottom of a standard hood should be 30” (76.2 cm) min. to 36” (91.4 cm) max. above the countertop. This would typically result in the bottom of the hood being 66” (167.6 cm) to 72” (182.9 cm) above the floor. Refer to the rangehood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood.
Wood/CompositeOverlay
(167.66”min. | |
6 | cm) |
to | |
(182.72”max. | |
9 | cm) |
|
24” | |
.0 | cm) |
(61 |
|
30”min.(76. | ||
2 | cm) | |
|
| |
to | ||
36”max. | ||
(91. |
|
|
4 | cm) | |
|
| |
|
|
|
• Wall cabinet above the cooktop |
must be a minimum of 36” |
(91.4 cm) above the countertop |
for a full width of the cooktop. |
The minimum height requirement |
does NOT apply if a rangehood is |
installed over the cooking surface. |
|
|
|
|
|
|
|
|
|
| . |
|
|
|
|
|
|
|
|
|
| max |
| |
|
|
|
|
|
| 13” | 0 | cm) |
| ||
|
|
|
|
|
| (33 | . |
|
| . | |
|
|
|
|
|
|
|
|
| |||
|
|
| . |
|
|
|
|
|
|
| min |
|
|
|
|
|
|
|
|
| 36” | cm)* | |
| min |
|
|
|
|
|
| .4 |
| ||
|
|
|
|
|
|
| (91 |
| |||
18” |
| cm | ) |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| ||
.7 |
|
|
|
|
|
|
|
|
|
| |
(45 |
|
|
| 6” |
|
|
|
|
|
| |
|
|
|
| (15. |
| min |
|
|
|
|
|
|
|
|
| 2 |
|
|
|
|
|
| |
|
|
|
| cm)** | . |
|
|
|
| ||
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
Wood/CompositeOverlay
|
| |
(167.66”min. | ||
6 | cm) | |
to | ||
(182.72”max. | ||
9 | cm) | |
|
|
30” | ||
.2 | cm) | |
(76 |
|
|
6” |
| |
.2 | cm) | |
(15 |
|
|
Wall Installation
30”min(76. . | |
2 | cm) |
| |
to | |
36”max. | |
(91. |
|
4 | cm) |
|
|
|
| . |
|
| min | |
36” | 4 | cm) | |
(91 | . |
|
|
|
|
|
Dimensions shown are for use with combustible surfaces unless otherwise stated.
*Note: 36” minimum unless using a hood.
**Note: Only applies to combustible surfaces.
***Note: Refer to installation of holddown brackets on page 13 for minimum clearances under counter
| 3 |
|
| - | |
(7 | . | 1/8” |
| ||
| 9 | cm) |
|
|
(0 | 0” | min |
| |
. |
|
| ||
| 0 | cm) | . | |
|
| |||
|
|
|
|
Island Installation
8 | 9 |