KitchenAid KPS2CL manual Beater To Bowl Clearance

Page 12

Beater To Bowl Clearance

Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away from the bowl, you can correct the clearance easily.

1. Unplug Stand Mixer.

2. Place bowl lift handle in down position.

3. Attach flat beater.

4. Adjust so flat beater just clears

A

bottom surface of bowl when in lifted position by turning screw (A) clockwise to raise the bowl and counterclockwise to lower the bowl. Just a slight turn is all that is required: the screw will not rotate more than 14 turn (90 degrees) in either direction. The full range of adjustment is 12 turn, or 180 degrees.

5.Place bowl lift handle in up position to check clearance.

6.Repeat steps 4 and 5 if necessary.

NOTE: When properly adjusted, the flat beater will not strike the bottom or side of the bowl. If the flat beater or the wire whip is so close that it strikes the bottom of the bowl, the beater or whip may wear.

10

Image 12
Contents Commercial Mixer Hassle-Free Replacement Warranty Proof of Purchase & Product RegistrationTable of Contents Important Safeguards Your safety and the safety of others are very importantPage KitchenAid Stand Mixer Warranty For Puerto Rico Arranging for Service After the Warranty ExpiresOrdering Accessories and Replacement Parts Troubleshooting Problems Electrical RequirementsModel KM25G0X Only Mixer Features Assembling Your Mixer Using Your KitchenAid Attachments Mixing TimeMixer Use Speed Control Guide 10 Speed Mixers SpeedBeater To Bowl Clearance Mixing Tips Basic White Bread Care and Cleaning To Remove the Bowl Support for CleaningCare and Cleaning Accessories Pouring Shield Mixer CoversModel KPS2CL for 5 quart models Model K5CRPage Page For the WAY IT’S Made
Related manuals
Manual 4 pages 14.79 Kb