IMPORTANT NOTES
•Avoid installing this unit in places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, on top of other stereo equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/or humid or moist areas.
•Operate controls and switches as described in the manual.
•Before turning ‘On’the power, make certain that the power cord is properly installed. When moving the set, be sure to first disconnect the power cord.
•Store your CDs, in a cool area to avoid damage from heat.
CLASS 1 LASER PRODUCT
CLASS 1 LASER PRODUCT | CAUTION | |
INVISIBLE LASER RADIATION | ||
| ||
APPAREIL Á LASER DE CLASSE 1 | WHEN OPEN AND INTERLOCKS | |
PRODUCTO LASER DE CLASE 1 | DEFEATED. | |
AVOID EXPOSURE TO BEAM | ||
|
This product contains a low power Laser Device.
FCC Information
This equipment has been tested and found to comply with the limits for a class B digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
3
CKD9906_071905.p65 | 3 |
19/7/2005, 14:26