KitchenAid 2300269 manual Reinstall the Gasket, Install the Door

2.Place the door and overlay frame face down on the cardboard.

3.Use the holes in the door frame as guides and drill pilot holes for the screws that will attach the overlay frame to the door.

IMPORTANT:

■Do not use a drill bit larger than ⁷₆₄ ".

■Do not drill deeper than ³₈ " (9.53 mm).

■For correct door operation, align the overlay frame and door frame properly.

4.Using ten of the #6 x 1" pan-head screws attach the door to the overlay frame.

A

A. #6 x 1" pan-head screws (10)

5.Remove the masking tape holding the overlay frame to the door frame.

Reinstall the Gasket

1.Starting at the corners and working toward the center of each side of the door, push the door gasket back into place.

2.Be sure the door gasket is fully installed on all four sides of the door.

Install the Door

IMPORTANT: To ensure proper operation, the pivot posts must be clean and the closers must be clean and greased with petroleum jelly.

1.Remove the door closer–top and door closer–bottom from the bottom hinge. Clean thoroughly and apply petroleum jelly to the mating surfaces of the closers.

2.Install the door closer–bottom and door closer–top on the bottom hinge.

IMPORTANT:

■Be sure to properly align the door closer–bottom bosses with the holes in the bottom hinge.

■Be sure to properly align the door closer–top bosses with the holes in the hinge plate.

3.Position the door onto the door closer assembly.

A

B

C

D

	G
E
F
A. Door frame	E. Pivot post
B. Pivot plate	F. Bottom hinge
C. Door closer–top	G. Bosses
D. Door closer–bottom

4.Position the door frame and install the pivot post on the top hinge. Using a ⁷⁄₆₄" Allen wrench, secure the pivot post.

A

B

C

A. Pivot post

B. Top hinge

C. Top pivot plate

5.Adjust the door frame as needed for proper closure. See “Door Closing.”

7