Assembling Your Tilt-Head Stand Mixer
To Attach Bowl
1.Turn speed control to “O”.
2.Unplug stand mixer or disconnect power.
3.Hold the locking lever in the UNLOCK position and tilt motor head back.
4.Place bowl on bowl clamping plate.
5.Turn bowl gently in clockwise direction.
To Remove Bowl
1.Turn speed control to “O”.
2.Unplug stand mixer or disconnect power.
3.Hold the locking lever in the UNLOCK position and tilt motor head back.
4.Turn bowl counterclockwise.
Pin
To Attach Flat Beater, Wire Whip, or Dough Hook
1.Turn speed control to “O”.
2.Unplug stand mixer or disconnect power.
3.Hold the locking lever in the UNLOCK position and raise motor head.
4.Slip beater onto beater shaft and press upward as far as possible.
5.Turn beater to right, hooking beater over pin on shaft.
To Remove Flat Beater, Wire Whip, or Dough Hook
1.Turn speed control to “O”.
2.Unplug stand mixer or disconnect power.
3.Hold the locking lever in the UNLOCK position and raise motor head.
4.Press beater upward as far as possible and turn left.
5.Pull beater from beater shaft.
To Lock Motor Head
1.Make sure motor head is completely down.
2.Place locking lever in LOCK position.
3.Before mixing, test lock by attempting to raise head.
To Unlock Motor Head
1.Place lever in UNLOCK position. NOTE: Motor head should always be kept in LOCK position when using mixer.
O 1 2 4 6 8 10
To Operate Speed Control
Plug mixer in proper electrical outlet. Speed control lever should always be set on lowest speed for starting, then gradually moved to desired higher speed to avoid splashing ingredients out of bowl. See page 9 for Speed Control Guide.
English
5