KitchenAid 5KSM150PS, 5K45SS manual Beater to Bowl Clearance

Page 9

Beater to Bowl Clearance

Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away from the bowl, you can correct clearance easily.

1.Turn speed control to “O”.

2.Unplug stand mixer or disconnect power.

3.Lift motor head.

4.Turn screw (A) SLIGHTLY counter

clockwise (left) to raise flat beater

 

or clockwise (right) to lower flat

 

beater.

 

5. Make adjustment with flat beater,

 

so it just clears surface of bowl.

A

If you over adjust the screw, the

 

bowl lock lever may not lock into place.

NOTE: When properly adjusted, the flat beater will not strike on the bottom or side of the bowl. If the flat beater or the wire whip is so close that it strikes the bottom of the bowl, coating may wear off the beater or wires on whip may wear.

English

7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents TILT-HEAD Stand Mixers Table of Contents Important Safeguards Electrical Requirements 5K45SS Tilt-Head Stand Mixer Features 5KSM150PS Tilt-Head Stand Mixer Features Assembling Your Tilt-Head Stand Mixer Assembling Your Pouring Shield Using Your KitchenAid AccessoriesBeater to Bowl Clearance Care and Cleaning Planetary Mixing ActionStand Mixer Use Number of Speed Stir Speed Control Guide 10 Speed MixersMixing Tips Mixing and Kneading Yeast Dough Whipped Cream Egg WhitesGeneral Instructions Attachments and AccessoriesGeneral Information To AttachWhen You Need Service Service Centers Household KitchenAid Tilt-Head Stand Mixer WarrantyFor the WAY IT’S Made Customer Service
Top Page Image Contents