Assembling Your Mixer
To Attach Bowl
1.Turn speed control to OFF.
2.Unplug Stand Mixer or disconnect power.
3.Place bowl lift handle in down position.
4.Fit bowl supports over locating pins.
5.Press down on back of bowl until bowl pin snaps into spring latch.
6.Raise bowl before mixing.
7.Plug into a grounded 3 prong outlet.
To Remove Bowl
1.Turn speed control to OFF.
2.Unplug Stand Mixer or disconnect power.
3.Place bowl lift handle in down position
4.Remove flat beater, wire whip, or dough hook.
5.Grasp bowl handle and lift straight up and off locating pins.
To Raise Bowl
RAISE
1.Rotate handle to
2.Bowl must always be in raised, locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
WARNING
Injury Hazard
Unplug mixer before touching beaters.
Failure to do so can result in broken bones, cuts or bruises.
To Attach Flat Beater, Wire Whip, or Dough Hook
1.Turn speed control to OFF.
2.Unplug Stand Mixer or disconnect
power.
3. Slip flat beater on beater shaft
and press | PIN |
| |
upward as far |
|
as possible. |
|
4.Turn beater to right, hooking beater over the pin on shaft.
5.Plug into a grounded 3 prong outlet.
To Remove Flat Beater, Wire Whip, Or Dough Hook
1.Turn speed control to OFF.
2.Unplug Stand Mixer or disconnect power.
3.Press beater upward as far as possible and turn left.
4.Pull beater from beater shaft.
5.Plug into a grounded 3 prong outlet.
Commercial mixer SPEED Control and Lever Guard
RESET
OFF/0STIR2 4 6 8 10
The Soft Start™ feature minimizes
Auto-Reset Motor Protection
If the Stand Mixer stops due to overload, slide the speed control lever to OFF. After a few minutes, the stand mixer will automatically reset. Slide the Speed Control Lever to the desired speed and continue mixing. If the unit does not restart, see “Troubleshooting Problems” on page 5.
7