KitchenAid KEBU107SSS BUILT-IN Oven Safety, Installation Requirements, Tools and Parts

Page 2

BUILT-IN OVEN SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean:

DANGER

WARNING

You can be killed or seriously injured if you don't immediately follow instructions.

You can be killed or seriously injured if you don't follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

Adjustable wrench or ⁵⁄₈" wrench

Phillips screwdriver

Flat-blade screwdriver

Measuring tape

Hand or electric drill (for wall cabinet installations)

1" (25 mm) drill bit (for wall cabinet installations)

Level

Copper tubing cutter

Parts supplied (1 box, 3 plastic bags)

One - ³⁄₈" stem to ¹⁄₄" quick connect

Two - ³⁄₈" elbow to ¹⁄₄" quick connects

Water filter

#10–16 x ⁵⁄₈" screw and 1 mounting ring (to mount water filter)

#8–14 x 1" screws - single oven (2), double oven (4)

Bottom vent (supplied on some models)

#8–18 x ³⁄₈" screws - bottom vent (supplied on some models)

Parts needed

UL listed or CSA approved conduit connector

UL listed wire connectors

Tubing staples/retainers

¼" O.D. copper tubing (to make water connection)

NOTE: Due to temperatures around oven, copper tubing is required.

Water connection device (to connect ¼" O.D. copper tubing to water source). Check local codes for type of connection required.

¼" to ¼" water supply union (between copper tubing from the filter and copper tubing attached to oven)

Check local codes. Check existing electrical supply. See “Electrical Requirements.”

It is recommended that all electrical connections be made by a licensed, qualified electrical installer.

Built-In Oven Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with oven.

Recessed installation area must provide complete enclosure around the recessed portion of the oven.

Grounded electrical supply is required. See “Electrical Requirements” section.

Electrical supply junction box should be located 3" (7.6 cm) maximum below the support surface when the oven is installed in a wall cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to route the oven conduit through to the junction box.

NOTE: For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If you are installing the junction box on rear wall behind oven, the junction box must be recessed and located in the upper or lower right or left corner of the cabinet; otherwise, the oven will not fit into the cabinet opening.

2

Image 2
Contents Table of Contents/Table des matières Tools and Parts BUILT-IN Oven SafetyInstallation Requirements Built-In Oven Location RequirementsProduct Dimensions Double Ovens Product Dimensions Single OvensCabinet Dimensions Single Ovens Electrical Requirements Water Filtration System Location RequirementsWater Supply Requirements Remove Oven Door Installation InstructionsPrepare Built-In Oven Electrical ConnectionMake Electrical Connection Electrical Connection Options ChartWire Cable from Home Power Supply If your home has Go to sectionInstall Water Filter Install Water Filtration SystemWire Cable from Home Power Supply U.S. Only Connect to Home Water SupplyConnect to Water Filter Outlet blue Install OvenIf you need to release tubing Check Operation of Single Oven Complete InstallationIf you need Assistance or Service Check Operation of Double OvenSécurité DU Four Encastré Votre sécurité et celle des autres est très importanteOutillage et pièces Exigences D’INSTALLATIONExigences d’emplacement du four Encastré Dimensions du produit Four double Dimensions du produit Four simpleDimensions du placard Four simple Four simple installé dans un placardConfiguration dinstallation typique Exigences demplacement du système de Filtration de l’eauDimensions du placard Four double Four double installé dans un placardAlimentation en eau par osmose inverse Spécifications de l’alimentation en eauSpécifications électriques Raccordement électriqueDépose de la porte du four Instructions DinstallationPréparation du four encastré Raccordement électriqueTableau des options de raccordement électrique Installation du filtre à eauInstaller le filtre à eau Sil est nécessaire de relâcher le tube Raccordement à la canalisation deauRaccordement à l’entrée du filtre à eau jaune Raccordement à la sortie du filtre à eau bleuInstallation du four Vérification du fonctionnement du four simple Achever linstallationSi vous avez besoin dassistance ou de service Vérification du fonctionnement du four doubleW10140563A