Using Your Kambrook Blender
Before First Use
Remove and safely discard any packaging material and promotional labels.
Disassemble the blender jug by following the steps in the ‘Disassembling the Blender’ section below. Wash the lid, inner cap, blender jug, silicone seal and Removable Blade Holder in warm, soapy water with a soft cloth. Rinse and dry thoroughly.
Wipe the motor base with a damp cloth and dry thoroughly.
Disassembling the Blender
1.Place the motor base on a flat, dry surface such as a bench top. Ensure that the Speed Control Dial is in the ‘OFF’ position, the appliance is switched off at the power outlet and the power cord is unplugged.
2.Hold the base with one hand and with the other hand turn the blender jug handle anti- clockwise and in the opposite
direction of the ‘’ symbol on the motor base.
3.Remove the lid and inner cap from the blender jug.
4.Place the jug upside down on a flat, dry surface such as a bench top.
5.Using the inner cap, insert the two tabs on the inner cap into the Removable Blade Holder (See Fig. 1).
Fig. 1
6.Use one hand to hold the jug handle and the other hand to turn the inner cap clockwise
to ‘’ the Removable Blade Holder (See. Fig. 2).
Fig. 2
7.Once loose, tilt the Removable Blade Holder at an angle and lift it up and out of the jug.
WARNING: Blades must be handled carefully as they are sharp!
7