Kambrook KQK600 manual Operating Instructions, Operating Your Kambrook HOT CUP, Before First USE

OPERATING INSTRUCTIONS

OPERATING YOUR KAMBROOK HOT CUP

BEFORE FIRST USE

Remove any packaging material and promotional labels before using your kettle for the first time.

It is recommended with due care and attention placed on the following precautions before operating the Hot Cup.

WARNING: This kettle dispenses 250ml of hot water continuously per operation.

It is not possible to interrupt and stop the hot water flowing out from the dispensing spout once one cup of water (250ml) has boiled. Therefore, you MUST ensure that a vessel/cup is capable of holding a minimum of 280ml capacity and is placed under the dispensing spout of the kettle on the drip tray. Do not overfill the cup as the water is very hot.

The appliance should always be placed on a firm level surface where normal access from persons (including children) with reduced physical, sensory or mental capabilities is restricted.

It is recommended that a vessel/cup capable of accommodating a minimum of 280ml of very hot water is placed under the dispensing spout at all times to capture the dispensed water should the unit be inadvertently turned on.

It is recommended that before the first use to fill the kettle to the maximum level with cold tap water, carry out several boil cycles discarding the water each time from a vessel/cup capable of holding a minimum of 280ml capacity. Then, discard the water inside the water chamber as following.

EMPTYING YOUR RAPID BOIL

1.After the Hot Cup has completely cooled down, unplug it from the mains supply socket.

2.Press the lid release button.

3.Hold your kettle sideways over a sink.

4.Then, tip the Hot Cup upside down.

5.Still holding the Hot Cup over the sink, turn it the right side up and allow any water to drain out of the spout.



6.Repeat steps 3, 4 and 5 until the water has been emptied from the Hot Cup.

Your kettle will only operate when positioned on the power base with the ON/OFF switch in the ON position. The kettle will automatically switch off once the water has boiled.

Note: The maximum capacity of the Kettle is 1.5L.

OPERATION OF YOUR KETTLE

1.To fill the kettle with water, remove it from the power base and open the lid by pressing the lid release button. The lid will automatically open.

2.Fill with the desired amount of water. Do not operate the kettle without water. Always fill the kettle between the minimum and the maximum marks on the water window. Too little water will result in the kettle switching off.

3.Ensure that the lid is closed and locked firmly into place before placing the kettle on the power base. Place the kettle firmly onto the power base. Plug the power cord into 230/240V power outlet and switch ‘ON’.

4.Press the ON/OFF switch to the ‘ON’ position. The power ‘ON’ light will illuminate.

Note: In choosing the size of vessel/cup, it is recommend the capacity is not less than 280ml, make sure the vessel/cup is positioned in place before using. Do not overfill the cup.

5.The kettle will switch off automatically once one cup of water (250ml) has boiled.

6.The hot water will flow out from the spout under 60 seconds. Before removing cup, make sure the water flow has ceased.

Note: The water flowing out from spout is hot and contact with the hot water may result in scalding. Therefore, this appliance should not be used

by children.

If you want to boil water again, simply press the power ON/OFF switch to ‘ON’ position again.

If further heating of the kettle is not required, switch off at the power outlet, unplug the power cord and empty the water from the kettle. Replace the kettle onto the power base and close the lid.