Troubleshooting, Winterizing | KitchenAid OUTDOOR ICE MAKER specs

3.Remove the slope by bending it in the center and releasing it from the shafts.

4.Remove the water tank, and drain the water.

5.Remove the separators by lifting each separator up and pushing back.

6.Lift off the ice chute from the rear and front frames.

A. Frame Pipe

B. Ice Chute

7.Below the ice chute is the spray assembly. Pull the discharge tube from the spray assembly and pull the assembly toward you.

Vacation and Moving Care

To shut down the ice maker:

1.Unplug ice maker or disconnect power.

2.Shut off the water supply and open the drain valve.

3.Remove all ice from storage bin.

4.Remove the water tank and drain the water.

5.After the water has drained from the ice maker, close the drain valve.

6.Before using again, clean the ice maker and storage bin.

7.Discard the first 3 batches of ice produced.

NOTE: All components of the ice maker are permanently lubricated at the factory. They should not require any additional oiling throughout the normal life of the machine.

Winterizing

The ice maker must be shut down if temperatures drop below

45°F (7°C). Additionally, if temperatures drop below 32°F (0°C) the water must be drained completely from the ice maker and all water lines to avoid damage.

1.Remove the water tank and drain the water.

2.After the water has drained from the ice maker, close the drain valve.

3.Before using again, clean the ice maker and storage bin.

4.Discard the first 3 batches of ice produced.

A. Discharge tube

B. Frame pipe

C. Spray assembly

8.Remove the two caps from the side of the spray assembly.

A. Spray Nozzles

B.Caps

9.Wash the interior components with mild soap or detergent and warm water. Rinse in clean water. Then clean the same parts with a solution of 1 tbs. (15 mL) of household bleach in 1 gal. (3.8 L) of warm water. Rinse again thoroughly in warm water. If the nozzles on the spray assembly are clogged, clean them with a wire brush.

10.Clean the scoop and inside of the ice bin.

11.Replace the caps on the spray assembly and slide it back into place. Reattach the discharge tube.

12.Slide in the ice chute until it clicks into place.

13.Replace the water tank, separators and slope.

14.Plug in ice maker or reconnect power.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Unit does not run

■Is the control set to ICE? Be sure that the control is set to ICE.

■Is the power cord plugged in? Plug into a grounded 3 prong outlet.

■Has a household fuse or circuit breaker tripped? Replace the fuse or reset the circuit.

■Is the temperature cooler than normal? Ambient temperature must be above 45°F (7°C). Otherwise, bin thermostat may sense cold ambient temperature and shut off even though bin is not full of ice. Also, unit may not restart once it does shut off.

Unit runs but produces no ice

■Is the control set to ICE? Be sure that the control is set to ICE.

■Is the water supply connected? Make sure the water supply is properly connected and turned on.

Unit runs but produces very little ice

■Is the temperature hotter than normal? Ambient temperatures of more than 100°F (37°C) will normally reduce ice production.

■Is the condenser dirty? Dirt or lint may be blocking the airflow through the condenser. See the “Condenser” section.

OUTDOOR ICE MAKER specifications

The KitchenAid Outdoor Ice Maker is a perfect blend of style, functionality, and durability, making it an essential addition for outdoor kitchens and patios. Designed for those who love entertaining outdoor, this appliance ensures you never run out of ice during your gatherings.

One of the standout features of this ice maker is its ability to produce up to 50 pounds of ice per day, meaning you can keep your drinks cool without constant refills. It features a large-capacity storage bin that holds about 25 pounds of clear, elegant ice, ensuring that you have a steady supply on hand. The unit's compact design allows it to fit seamlessly into any outdoor kitchen setup, making it both practical and aesthetically pleasing.

The KitchenAid Outdoor Ice Maker uses advanced technology to deliver clear ice that melts slowly and maintains the quality of your beverages. The unit employs a commercial-grade compressor that ensures efficient ice production, even in varying outdoor temperatures. With a built-in drain pump, it automatically manages wastewater, making installation easy in various outdoor settings.

In terms of design, this ice maker is crafted from stainless steel, which not only enhances its visual appeal but also provides resistance to rust and corrosion. The sleek finish complements outdoor grills, refrigerators, and other appliances, creating a cohesive look for your culinary space. The front-facing venting design allows for easy installation flush against cabinetry, maximizing your outdoor area while maintaining functionality.

Moreover, the user-friendly control panel allows you to select ice production settings effortlessly. LED lighting within the storage bin makes it easy to see the ice level, ensuring you never run low unexpectedly. The exterior also features a reversible door, providing flexibility in terms of installation orientation.

In summary, the KitchenAid Outdoor Ice Maker combines superior ice-making capacity with advanced features, durable design, and practical technology to enhance any outdoor entertaining experience. Whether hosting a summer barbecue or enjoying a cozy evening by the fire, this ice maker ensures that you are always prepared with fresh, high-quality ice at your fingertips.