KitchenAid W10300928C Problem Solution Damage to Dishware, Blinking Lights, Etching Permanent

PROBLEM	SOLUTION
DAMAGE TO DISHWARE	Improper loading can cause dishes to become chipped or damaged. (See specific loading
	instructions within this guide.)
BLINKING LIGHTS	Blinking LED's will occur when the cycle is paused or when the cycle has been interrupted by
	opening the door. In this case, the Start/Resume button LED, the Cycle Status Indicator LED(s), and
	the countdown bars on the Cycle Status Display all blink together to indicate that attention is
	needed. See Start or Resume a Cycle in the “Dishwasher Use” section.
	Blinking LED's can also occur when certain errors have been detected. In this case, the Clean/
	Complete LED will blink one time with a pause in between blinks.
	Call for service.

CLOUDY OR SPOTTED DISHWARE (AND HARD WATER SOLUTION)

NOTES:

■Liquid rinse aid is necessary for drying and to reduce spotting.

■Use the correct amount of detergent.

Confirm that the cloudiness is removable by soaking the item in white vinegar for 5 minutes. If the cloudiness disappears, it is due to hard water. Adjust the amount of detergent and rinse aid. (See “Hard Water [White Residue On Dishwasher Interior Or Glassware] in “Troubleshooting.”) If it does not come clear, it is due to etching (see below).

Be sure the incoming water temperature is set at 120°F (49ºC).

	Try using the High Temp and Sani Rinse options.
	To remove spotting, run a vinegar rinse through the dishwasher.
	■ Wash and rinse the affected dishware and load into dishwasher. Remove all silverware and metal
	items. Put 2 cups (500 mL) of white vinegar in a glass measuring cup in the lower rack. Run a
	normal cycle with the Heat Dry option turned off. No detergent is needed.
ETCHING (PERMANENT	This is an erosion of the surface of the glassware and can be caused by a combination of: water that
CLOUDINESS)	is too hot, from using too much detergent with soft water or by pre-washing. Detergent needs food
	soil to act upon. If etching has occurred, the glassware is permanently damaged. To avoid further
	etching, adjust the detergent amount to match the water hardness, stop pre-washing, and use water
	heating options only when incoming water temperature is below 120°F (49°C).
LEAKING WATER	Be sure dishwasher has been installed properly and is level.
	Suds can cause the dishwasher to overflow. Measure the detergent accurately and use only
	detergents designed for use in a dishwasher. Less detergent is needed in soft water. Try another
	brand of detergent if sudsing continues.
	To avoid rinse aid leaking from the dispenser, be sure the lid is securely attached and avoid
	overfilling.
TUB IS DISCOLORED	NOTES:
	■ High iron content in the water can discolor the tub.
	■ Tomato-based foods can discolor the tub or dishware.
	A citrus-based cleaner can be used to clean.

15