Curtis RCD856 manual High Speed Music Search, Repeat Play Modes, Programmed Playback

Page 9

HIGH SPEED MUSIC SEARCH

During CD playback you may search forward or back within the tracks of the disc to locate a specific musical passage if desired. To perform high speed music search press and hold either the SKIP FORWARD or SKIP BACK buttons. Release the buttons when you locate the desired passage and normal playback will resume at high speed music search.

REPEAT PLAY MODES

There are 3 repeat options for your convenience. Pressing the REPEAT button will cycle the changer through the three modes as follows:

1st Press

Repeat All Tracks On All Discs In The Tray

2nd Press

Repeat All Tracks On One Disc

3rd Press

Repeat One Track

4th Press

Repeat Mode Off Normal Playback Resumes

PROGRAMMED PLAYBACK

The CD changer has a 32 track programmable memory that allows you to program up to a total of 32 tracks on 3 discs for playback in any order you choose. You may also program a specific track to be played more than once in a program sequence.

TO PERFORM PROGRAMMED PLAYBACK PROCEED AS FOLLOWS:

1Open the CD door and insert up to 3 discs in the tray, then close the door.

2At stop mode Press the PROGRAM button once. The display will show the 01 d1----. This indicates that the memory is ready to accept the first disc and track to be programmed.

3Select the first disc you wish to program by pressing DISC SKIP. For example, DISC2.the disc number will appear on the display as 01 d2----.

4Select the first track you wish to program by pressing SKIP FORWARD button until the desired track appears in the display, EDIT indicator will appear and flash. For example, TRACK7.The display will show 01 d2 07.

5When the display correctly shows the first disc and track number you wish to program, press the PROGRAM button again to enter the track number in the memory.Display will now appear as

02 d2: ----. This indicates that the memory is ready to accept the second track to be programmed. The EDIT indicator stop flashing.

6Repeat steps 3,4 and 5 until you have entered up to 32 tracks into the memory.

7When you finish programming press the PLAY/PAUSE button to begin programmed playback. The PROGRAM indicator appears in the display and the changer will play back the tracks and discs in the order in which you entered them into the in program memory.

NOTES:

Image 9
Contents Page To Reduce Table of Contents Location of Controls Inserting batteries in the remote control Remote ControlTuner Operation Operating InstructionCD Operation CD OperationHpause Indicator Gplay IndicatorNormal CD Playback Skip Track Forward or Back ButtonsRepeat Play Modes High Speed Music SearchProgrammed Playback To Perform Programmed Playback Proceed AS FollowsTo Confirm the Programmed Info Caring for Compact Discs