KitchenAid 5KSB555AGR Electronic Speed Control Board Replacement Fig, Motor Replacement Fig

Page 8

BLENDER SERVICE MANUAL

Electronic Speed Control

Board Replacement (Fig. 11)

To replace the electronic speed control board (9), disconnect filter connector (10), motor connector (11), and hall effect connector (12) from the electronic speed control board (9).

Using a flathead screwdriver, press tabs (13) on each side of control board (9) to remove from upper housing (5).

Motor Replacement (Fig. 13)

After the coupler (14) has been removed, disconnect the motor connector (11) and the hall effect connector (12) from the control board (9). Remove the two Phillips screws (16) and motor (17) from the upper housing (5).

Figure 11

To install the control board (9), snap into upper housing (5) and connect all connectors.

Coupler Replacement (Fig. 12)

The coupler (14), in the upper housing (5), can be removed by using a flathead screwdriver and a large pair of pliers. Place the screwdriver in the slot of the motor shaft (15). Hold the coupler (14) with the pliers. Turn the shaft clockwise to remove the coupler.

The coupler (14) is threaded in a left-hand manner on the end of the motor shaft. To install a new coupler, you will use a counterclockwise rotation. Avoid damage to the new coupler when installing by placing tape over the jaws of the pliers.

Figure 13

EMI Filter Replacement (Fig. 14)

To remove the EMI filter (18), disconnect connector (7) from the power cord (4) and disconnect connector (10) from the electronic speed control board (9). Remove a Phillips screw (19) and EMI filter (18) from the upper housing (5).

Figure 14

Figure 12

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Midline Blender Australian SeriesBritain Series European SeriesTechnician Service EnvironmentElectrical Considerations Blender Repair Manual Before First Use Product FeaturesPreparing the Blender for Use Blender Assembly Preliminary Inspection of Blender Operating the KitchenAid BlenderContinuous Operation Pulse OperationPower Cord Replacement Fig Blender Service ProceduresPower Base Access Fig Electronic Speed Control Board Replacement Fig Motor Replacement FigCoupler Replacement Fig EMI Filter Replacement FigFinal Inspection Model and Serial NumbersHall Effect Sensor Fig Parts List Unit Parts For Variations of Model 5KSB555AAttachment Parts For Variations of Model 5KSB555A Item No DescriptionUnit Parts For Variations of Model 5KSB555B Attachment Parts For Variations of Model 5KSB555B Unit Parts For Variations of Model 5KSB555E Attachment Parts For Variations of Model 5KSB555E Unit Parts For Variations of Model 5KSB555S Attachment Parts For Variations of Model 5KSB555S For the WAY IT’S MADE. TM
Top Page Image Contents