Getting Started
Unpacking your
RCD719 MP3 Micro System
Carefully remove your CD micro system from its packaging. You may wish to store the packaging for future use.
Box Contents:
-CD/MP3 micro system
-2 speakers (speaker cables attached)
-Remote control
-AM Loop Antenna
-User Guide
AC CONNECTION
Plug the power cord into an AC outlet having 120v,60Hz only. Connecting this unit to other power sources may damage the unit.
NOTES:
*The AC polarized plug helps to minimize the possibility of electric shock. If the polarized plug does not fit into a nonpolarized AC outlet, do not file or cut the wide blade; it is the user`s responsibility to have an electrician replace the obsolete outlet.
*The power cord should be unplugged from the outlet when the unit is not going to be used for a long period of time.
Installation
Speaker Connection
1.Unwind the cable from each speaker.
2.At the rear of the CD micro system there are two speaker sockets.
3.Plug the speaker located on the left into the socket marked ‘L’ and coloured white.
4.Plug the speaker located on the right into the socket marked ‘R’ and coloured red.
5.For optimal stereo effect, place the speakers approximately 1.5m apart.
AC Power Connection
1.Connect the mains plug to a mains supply socket and switch on the supply.
2.At the front of the CD micro system unit, press the STANDBY button.
3.The LCD display will light up.
Antenna
The FM antenna is attached to the back of the unit. Unwind the wire. Positioning is described in the Radio section.
The AM antenna is a separate loop aerial that plugs into the back of the unit at the socket marked ‘AM ANT.’. Its assembly is described in the Radio section.
4