Curtis RCD836 Preparation of Use, Compact Disc, How To Replace The Turntable Stylus?

Compact Disc

Handing the Discs:

This unit has been designed specifically for sound

reproduction from compact discs bearing the mark.

AUDIO

No other discs can be used.

1. Always place the compact disc in the disc tray with the label facing upward. (Compact discs can be played only on one side).

2.To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it

carefully by the edge.

HANDLE DISC ONLY AS SHOWN

3. Fingermarks and dust should be carefully wiped off the disc recorded surface with a soft cloth (not included)

CLEAN FROM CENTER TO EDGE

Preparation of Use

1. Connect the AC power cord.

2.The silver screw protects the phonograph chassis during transportation. If the speed of your phonograph seems slow or you hear a rubbing sound, adjust the screw with a coin to correct the balance of the turntable.

4.Never use such chemicals as record sprays, anti-static sprays or fluid, benzine or thinner to clean compact discs. Such chemicals will do irreparable damage to the disc's plastic surface.

5.Discs should be return to their cases after use to avoid serious scratches that could

cause laser pickup to skip.

6. Do not expose discs to direct sunlight or high humidity and temperature for extended periods. Long exposure to high temperature can warp the disc.

7.Do not stick paper or write anything with a ballpoint pen on the surface of the label side.

8.Do not use irregular shaped CD's (octangonal, heart-shape, etc.) Which can damage the

unit.

How To Replace The Turntable Stylus?

Removing old stylus

1.Set a screwdriver at the tip of the stylus and push down to the direction "A".

2.Remove the stylus by pulling it forward and down.

Installing a new stylus

1.Hold the tip of the stylus and insert the other edge by pressing in the direction "B".

2.Push up in the direction "C" until it locks at the tip.

A

C

6

B

Guide Pins (inside)

7