KitchenAid 8285418 Electrical requirements, Gas, Recommended ground method, To cooktop

Page 6
gas supply line

L.P. Gas:

No attempt shall be made to convert the cooktop from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. Conversion must be done by a qualified service technician. To convert to L.P. gas, use L.P. gas conversion kits part no. 8285442 and 8285443. The parts for these kits are in the literature package supplied with cooktop.

D.Provide a gas supply line of 3/4" rigid pipe to the cooktop location. A smaller size pipe on long runs may result in insufficient gas supply. Pipe-joint compounds, suitable for use with L.P. gas, must be used. With L.P. gas, piping or tubing size can be 1/2" minimum. L.P. gas suppliers usually determine the size and materials used on the system.

E.If local codes permit, use a flexible stainless steel tubing gas connector, design-certified by AGA or CSA International, to connect the cooktop to the rigid gas supply line. 5/8" diameter line is recommended. Do Not kink or damage the flexible connector when moving the cooktop. The pressure regulator has 1/2" female pipe threads. You will need to determine the fittings required, depending on the size of your gas supply line, flexible metal connector and shutoff valve.

shutoff valve “open” position

to cooktop

F.The supply line shall be equipped with an approved shutoff valve. This valve should be located in the same room as the cooktop and should be in a location that allows ease of opening and closing. Do Not block access to the shutoff valve. The valve is for turning on or shutting off gas to the appliance.

G.If rigid pipe is used as a gas supply line, a combination of pipe fittings must be used to obtain an in-line connection to the cooktop. All strains must be removed from the supply and fuel lines so cooktop will be level and in line.

H.The regulator must be checked at a minimum 1-inch (2.5 cm) water column above the set pressure. The inlet pressure to the regulator should be as follows for operation and checking the regulator setting:

NATURAL GAS:

Set pressure 5 inches (12.7 cm) W.C. Supply pressure 7-14 inches (17.8 cm to 35.5 cm) W.C. maximum.

L.P. GAS:

Minimum pressure 10 inches (25.4 cm) W.C.

Supply pressure 14 inches (35.5 cm) W.C.

I.Line pressure testing: Testing above 1/2 psi (3.5 kPa) or 14 inches (35.5 cm) W.C. (gauge) The cooktop and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psig (3.5kPa).

Testing below 1/2 psi (3.5 kPa) or 14 inches (35.5 cm) W.C. (gauge) or lower

The cooktop must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa).

Electrical requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3-prong outlet.

Do not remove ground prong. Do not use an adapter.

Failure to follow these instructions can result in death, fire, or electrical shock.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

Check with a qualified electrician if you are not sure whether the cooktop is properly grounded.

Do Not ground to a gas pipe.

A 120-volt, 60-Hz, AC-only, 15-ampere, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.

Electronic ignition systems operate within wide voltage limits, but proper ground and polarity are necessary. In addition to checking that the outlet provides 120-volt power and is correctly grounded, the outlet must be checked by a qualified electrician to see if it is wired with correct polarity. A wiring diagram is provided on the last page of these instructions.

Important: This cooktop is equipped with an electronic ignition system that will not operate if plugged into an outlet that is not properly polarized.

This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the current CSA standard C22.1. Canadian Electrical Code Part 1*.

Recommended ground method

For your personal safety, this cooktop must be grounded. This cooktop is equipped with a 3-prong ground plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong ground-type outlet, grounded in accordance with the National Electrical Code ANSI/NFPA 70 latest edition** or Canadian Electrical Code (CSA)* — and local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have a properly polarized and grounded, 3-prong outlet installed by a qualified electrician.

3-prong polarized ground-type outlet

3-prong ground plug

ground prong

power supply cord

Copies of the standards listed above may be obtained from:

*CSA International

8501 East Pleasant Valley Rd. Cleveland, Ohio 44131-5575

**National Fire Protection Association One Batterymarch Park

Quincy, Massachusetts 02269

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Backguard Required for some installations 36 91.4 cm Pro Line Series Commercial Style CooktopWhat to do if YOU Smell GAS Your safety and the safety of others are very importantBefore you start Electrical ground is required. See Electrical Requirements,Product Dimensions Side view of cooktop27.5 mm Cabinet and Cutout Dimensions Gas and Electric Connection Locations Gas and Electric DimensionsGas supply requirements Typical Gas and Electric ConnectionsRecommended ground method Electrical requirementsGas To cooktopInstallation Check the operation of the surface burners Standard Burner AdjustmentFor simmer burner flame adjustment Electronic Ignition System initial lightingIf you need service Installer checkoff listMaintenance If cooktop does not operate15 or 20 AMP Verify proper operation after servicingInstructions d’installation Dosseret Nécessaire pour certaines InstallationsAvant de commencer QUE Faire SI UNE Odeur DE GAZ EST PERCEPTIBLE?Votre sécurité et celle des autres Est très importante Dimensions du produit Table de cuisson vue latéraleDimensions placard et ouverture à découper Spécifications de l’alimentation en gaz Raccordement aux canalisations de gaz et de l’électricitéAvant de la table Spécifications de l’installation électrique Méthode recommandée de liaison à la terrePropane Électrode Vis avant 3 vis Arrière nécessairesChapeau de brûleur ’allumagePosition de Mijotage réglage Système d’allumage électronique allumage initialRéglage du brûleur Standard Tige de robinet OrificesEntretien Liste de contrôle de l’installateurSi vous avez besoin de services de réparation Si la table de cuisson ne fonctionne pas15 OU 250 PO

8285418 specifications

The KitchenAid 8285418 is a premium stand mixer accessory that adds versatility and efficiency to your culinary endeavors. This attachment is designed specifically for use with KitchenAid stand mixers, enhancing their functionality and enabling users to explore a wide array of recipes with ease.

One of the standout features of the KitchenAid 8285418 is its versatility. It comes with multiple components, allowing users to slice, shred, and spiralize vegetables and fruits. The adjustable slicing disc offers varying thickness settings, catering to personal preferences and different recipe requirements. The shredding disc includes fine and medium options, ensuring you have exactly the texture you need for your dishes. This variety helps in preparing everything from fresh salads to delicious toppings with minimal effort.

The technology behind the KitchenAid 8285418 is both intuitive and effective. The attachment operates smoothly with the stand mixer’s powerhub, utilizing the mixer's motor for consistent, efficient operation. This means you can slice or shred large quantities quickly without the hassle of a standalone food processor. The ease of attachment makes for a seamless transition between tasks, boosting your productivity in the kitchen.

Durability is another essential characteristic of the KitchenAid 8285418. Made with high-quality materials, this attachment is designed to withstand regular usage while maintaining its performance. Its components, including the slicing and shredding discs, can easily be detached for cleaning, making maintenance simple and efficient. Many parts are also dishwasher safe, allowing for a quick cleanup after a busy cooking session.

User-friendly design is an integral aspect of the KitchenAid 8285418. It includes a built-in food pusher that ensures safe and effective feeding of ingredients through the slicing and shredding mechanisms. This thoughtful design element not only enhances safety but also ensures that fruits and vegetables are processed effectively, maximizing yield and minimizing waste.

In summary, the KitchenAid 8285418 is a valuable addition to any kitchen, providing the versatility, durability, and user-friendly design you expect from KitchenAid products. Whether you're a culinary novice or an experienced chef, this attachment can significantly expand your culinary repertoire, making food preparation simpler and more enjoyable. With its array of features and technologies, the KitchenAid 8285418 stands as an essential tool for anyone looking to elevate their cooking experience.
Top Page Image Contents