–operation 1) and mark 2 holes with a pencil, drill the holes (Ø8mm), insert 2 wall plugs.
12. Fix the chimney support bracket to the wall using two 5x45mm screws.
13. Hook the hood onto the bottom bracket.
14. Fix the hood into its final position on the wall
(ABSOLUTELY ESSENTIAL).
15.Connect a pipe (pipe and pipe clamps not provided, to be purchased separately) for discharge of fumes to the connection ring located over the suction motor unit.
If the hood is to be used in ducting version, the other end of the pipe must be connected to a device expelling the fumes to the outside. If the hood is to be used in filter version, then fix the deflector F to the chimney support bracket G and connect the other extremity of the pipe to the connection ring placed on the deflector F.
16.Make the electrical connections.
17.Apply the chimney stacks and fasten them at the top to the chimney support „G“ (17b) using 2 screws (17a).
18.Slide the bottom section of the chimney down until it completely covers the suction unit and slots into the housing provided on top of the hood.
Replace the grease filter/s (and where foreseen the grease collecting panels) and check that the hood is operating correctly.
17a
17a
H
| 11 | 11 |
G 17b |
| |
12 |
| |
|
|
17b
188
8
6 | 16 | 15 | 3 |
|
| ||
|
|
| |
5 |
|
| 2 |
| 6 |
| B |
| 5 |
|
|
| 5 | 9 |
|
6 | 10 |
| |
|
|
| 9 |
14 |
| 10 | 7 |
|
| ||
17 |
|
|
|
14