Hotpoint LI2SNA manual Description of the appliance, Control panel

Page 5

Description of the appliance

Control panel

Calibrating the control panel

When the plug is inserted (or after a blackout) the system calibrates the keys; during calibration the display point flashes. Calibration lasts 15”. The point stops flashing at the end of calibration.

Off/Stand by: the On condition is obtained by

pressing for 3 seconds; in this case keys

and

are enabled, the display point and the blue led of the relative keys light up. The Off condition is

obtained by pressing again for 3 seconds.

On/Off lights: press to switch on the lights, which turn amber. Contemporaneously the symbols at

the sides and turn blue: the intensity of the light can be increased and diminished with these.

Once the luminosity has been set, pressing rapidly again memorises it (the symbol turns blue) and the light

switches off.

Secondary light (only for the models envisaged): press

for a long time to switch it on (at least a second);

press again for at least a second to switch it off.

On/Off motor: press to switch the motor on. It turns amber. Contemporaneously the symbols at the

sides and as well as turn blue.

Press or to adjust the intensity of

previously set. To exit from the function earlier press

or one of the following keys: , or

.

Fats filter signal: this symbol (red led) lights up

after 40 hours. Reset the signal by pressing for a long time (at least 3 seconds) until the beep confirms it.

Carbon filter signal action.

This signal is shown only if it has been previously set.

Proceed as follows: press with the hood in Off:

first turns red, after about 1 second also turns red. If you want to eliminate the carbon filter

signal previously set, press with the hood in Off. Reset the carbon filter signal (after 160 hours) by

pressing for a long time (about 3 seconds, until the beep).

suction. Pressing again switches the motor off and the last speed set is memorised.

Intensive timing: by pressing this key the suction of the hood becomes intensive for a maximum time of 5 minutes. At the end the hood returns to the speed

Image 5
Contents Instructions for Installation and Use Retention of this Instruction Book Installation InstallationAbsolutely Essential Control panel Description of the applianceFiltering version OperationExternal exhausting version Maintenance Disposal General safetyPage Page After Sales Service Key Contacts