Hotpoint RFA52K Maintenance and care, Switching the appliance off, Cleaning the appliance

Page 8

Maintenance and care

GB

Switching the appliance off

During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply:

It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact.

Cleaning the appliance

The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia.

The removable accessories may be soaked in warm water and soap or dishwashing liquid. Rinse and dry them carefully.

The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance.

Avoiding mould and unpleasant odours

The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly.

If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open.

Defrosting the appliance

!Follow the instructions below.

Do not speed up the defrosting process by using any devices or tools other than the scraper provided, you may damage the refrigeration circuit.

Defrosting the refrigerator compartment

The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate.

It is necessary to clean the discharge hole regularly so that the water can flow out easily.

Defrosting the freezer compartment

1.Set the TEMPERATURE ADJUSTMENT knob to the position .

2.Wrap frozen foods in newspaper and place them in another freezer or in a cool place.

3.Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment.

4.Clean and dry the freezer compartment carefully before switching the appliance on again.

5.Certain appliances are fitted with the DRAIN SYSTEM to lead the water

outside: let the water flow into a container (see diagram).

Replacing the light bulb

To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Follow the instructions below.

Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W).

8

Image 8
Contents Operating Instructions REFRIGERATOR/FREEZER CombinationInstallation Positioning and connectionPositioning LevellingFitting a new plug Remove the doors Replacing the doorsDescription of the appliance Overall viewICE tray Storage compartment Bottle shelfStarting the appliance Using the refrigerator to its full potentialStart-up and use Ice tray Using the freezer to its full potentialFast Freeze switch Maintenance and care Switching the appliance offCleaning the appliance Avoiding mould and unpleasant odoursPrecautions and tips General safetyDisposal Respecting and conserving the environmentTroubleshooting Malfunctions Possible causes / SolutionsGuarantee After Sales Service