Programme interruption
Carefully open the door, it could happen that water splashes out of the appliance. Only open completely when the spray arm no longer turns.
If the programme is already in ªdryingº mode, an acoustic signal reminds you to close the appliance door or to abort the programme.
Switch OFF the main switch 1 .
Indicator light goes out. The programme remains stored.
If warm water is connected or if the machine is already heated up and the appliance door has been opened, leave the door slightly ajar, then close it, otherwise the appliance door can jump open through the expansion.
In order to continue the programme flow, switch the main switch ON again and close the door.
en
Cancel programme (Reset)
Only when the master switch is ON.
Press the A and C programme
buttons simultaneously and hold them pressed for approx. 3 sec.
The programme continues for approx. 1 min.
The PROGRAMME END indicator and the indicator for the programme that has just been terminated light up.
Set main switch 1 to OFF.
Close the detergent compartment 30 . To restart the dishwasher, set main switch
1to ON again and select desired programme.
Changing the programme
It is possible to change the programme selection after you have switched the dishwasher on, provided that you have not yet closed the door.
If it is necessary to change the programme after this, the programme cycle that has already begun (e.g. washing) will still carry on to the end.
19