Wolfgang Puck BDFR0040 Assembling Your Fryer Drain Tap Cap, Using Your Deep Fryer

2006 Deep Fryer Manual_3 11/21/06 11:01 AM Page 13

Assembling Your Fryer

Drain Tap Cap

Drain tap lock

Drain tap

Drain tap cap

Figure 1 Figure 2

Your Wolfgang Puck Flash Fryer is equipped with a safety drain cap. Your drain tap cap should always be in place when using your deep fryer or when storing oil in the tank (see figure 1). The following directions outline the use of the drain tap.

1Place drain tap cap on drain tap by turning counter clockwise

until tight. Always ensure that your drain tap lock is closed whenever using your deep fryer, or when storing oil in your tank. Never unlock the drain tap lock with the tap cap on the drain tap.

2To remove drain tap cap first ensure that the tap lock is in the closed position. Turn drain cap clockwise to remove (see figure 2) and set aside.

3Place container under tap and unlock the drain tap lock to begin draining oil. Never drain hot oil, or while or deep fryer is plugged in.

4Your drain tap should be washed in warm soapy water and allowed to dry thoroughly.

Using Your Deep Fryer

	Assembling your Deep Fryer for Use
	1	Place the Deep Fryer housing on a stable,
		level surface.
	2	Ensure that all components of your Deep Fryer are
		completely dry prior to use to avoid risk of injury
figure 1
		due to spattering.
	3
		Insert the oil pot into the Deep Fryer housing
		ensuring that the front of the pot (the front is
		indicated by the tap) is placed at an angle into
		the housing. (See figure 1).
figure 2	4	Place the Oil Pot Filter Screen into the Oil Pot.
	5	(See figure 2).
		Line up the control panel into the grooves
		on the rear of the Deep Fryer housing. Your Deep
		Fryer is equipped with a safety microswitch which
		will not allow the control panel to work unless
		it is properly seated into both grooves in the
figure 3
	6	housing. (See figure 3).
		Add the appropriate amount of oil to the oil pot.
		Do not fill with oil above the maximum level or
		below the minimum level marked on the inside
		of the Deep Fryer pot. (See figure 4).
figure 4	7	Attach the Magnetic Release Power Cord into the
		receptacle on the back of the housing. Only use
		the approved receptacle marked TA-35P in your
		unit. To attach the receptacle ensure that the nubs
		on the magnetic end of the cord are on the right
		side of the plug (TA-35P) in order to line up with
		the plug receptacle on the Control Panel.
figure 5
		(See figure 5).
	8
		Unfold the basket handle and ensure that it is
		locked into place. (See figure 6).
	9	Place the basket into the basket holder inside
		the pot. (See figure 7).
figure 6

1 1

	12
figure 7