Maintenance and care
GB
Switching the appliance off
During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: It is not sufficient to set the temperature adjustment knobs on 
(appliance off) to eliminate all electrical contact.
Cleaning the appliance
•The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia.
•The removable accessories may be soaked in warm water and soap or dishwashing liquid. Rinse and dry them carefully.
Avoiding mould and unpleasant odours
Defrosting the appliance
The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced
by the compressor causes it to evaporate. It is not,
therefore, necessary to defrost the refrigerator manually. It is, however,
necessary to clean the
discharge hole regularly
so that the water can flow out easily.
Replacing the light bulb*
To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Follow the instructions below.
•The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly.
•If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open.
1 |
2 |
Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W).
*Available only on certain models.
8