Step 2
H Insert the filter holder (without espresso) into the brewing head. Do this by raising the filter holder up into the machine at a 45 degree angle (figure 4).
H Place at least a 5 oz. cup directly under the filter holder (see figure 5).
nMake sure the pump switch is in the ‘off” position. Using the ON/OFF button, turn “on” the appliance (see fig. 6 & 7).
The two indicator lights, yellow and red, will illuminate. Some water may drip out of the brewing head during the heating period. This is normal.
nSet the pump switch to the B position (see figure 6).
This will activate the pump. Upon first use, the emptY boiler will need to intake water into the boiler chamber, and You will hear a distinct initial thumping noise.
As soon as water is released from the filter holder, turn the pump switch back to the “off” position to allow the unit to reach the proper temperature.
Step 3
As soon as the yellow (thermostat) light goes out, the machine is properly heated and ready for use.
w Set the pump switch to the p position and let water run into cup, stopping and starting water flow by using the pump switch (see figure 9).
Repeat this process until half of the water in the water reservoir has been used.
This will require you to stay with the machine to empty each cup as it becomes full. Upon completion of each cup set pump switch to the “off” position.
Espresso is a far richer and stronger brew than regular coffee. It should be deep, dark and delicious. Most people find they enjoy it in small quantities because of its richness and for that reason, espresso is usually served in small
The mark of real espresso is its wonderful inviting fragrance and a light brown “Crema”, found on top of the surface of the coffee. Your “Espressso Vivo”, properly used, will always produce espresso that is deep, dark, and delicious. Just follow the instructions and use fresh, well roasted espresso beans.
If you choose to grind your own beans we recommend using the KRUPS II Barista #220.
Remember, espresso requires a much finer grind than regular coffee. We recommend grinding your espresso beans for approximately 60 seconds; or until it has a talcum powder appearance and texture.
Before you make Your first cup of delicious espresso, make sure that the boiler chamber has water.
With the water reservoir full, place a cup directly under the filter holder. Turn “on” the unit and set the pump switch to p. As soon as water begins to flow from the filter holder, the boiler is full. Set the pump switch back to the ‘off’ position. When the yellow thermostat light goes off, you are ready to make espresso.
Making Espresso
Step 1
nFill the water reservoir with fresh, cold water (figures
While making espresso, water can be added to the reservoir by opening the hinged water chamber lid and adding water to the
10