Complete Installation
1.Install vent cover.
■When using both upper and lower vent cover, push lower cover down onto hood and lift upper cover to ceiling and install screws.
A
B
A. Upper vent cover
B. Lower vent cover
■For reduced ceiling height installations, when using only the lower cover, push lower cover down onto hood and snap vent into place around vent cover bracket.
Install Filters
1.For
A
B
C C
A. Blower housing
B.Handle
C.Charcoal filters
2.For all installations, insert back edge of metal filter into rear channel of the filter opening.
3.Push handle toward the rear and push filter up.
4.Pull filter toward the front and insert into front channel.
Check Operation
1.Check operation of the range hood by turning the power on.
A | B |
O I | O 1 2 3 |
A. Light switch
B. Blower switch
2.Move the light switch to the “1” position. The light should turn on.
3.Move the light switch to the “0” position. The light should turn off.
4.Move the blower switch to the “1” position for low speed. “2” position for medium speed. “3” position for high speed.
5.Move the blower switch to the “0” position. The blower should turn off.
6.If range hood does not operate, check that the circuit breaker has not been tripped or the house fuse blown. Disconnect power supply and check that the wiring is correct.
9