Wireless Mic WMIC1 Quick Start Guide
1.Connect the Receiver to the USB Power adapter by the USB to DC Power ca- ble . Use the DC port (13 , see below ) on the Receiver.
2.Plug USB Power Adapter into a 115 VAC power outlet.
3.Turn Receiver power (12) to ON. The green LED will come on and continue to slowly blink.
4. Turn the switch (11) to 20dB / MIC
5.Press the Vol+ and Vol- ( 2 and 7 ) to get the display (5) to read 15.
6.Press the CH+ and CH- (4 and 9 ) to set the channel. A good choice is a chan- nel of 50 or above to reduce the potential of any WiFi interference. The display
(5) shows the channel.
7.Connect the 3.5 mm mini audio output port (6) with a 3.5 mm mini stereo cable to the MIC input or audio input on a projector or a sound system. The audio out is at line level.
Pg 1 of 2
RECEIVER
Blank , closed port
Green
AudioOutputout- jack, 3.5 mm
Set switch to 20dB / MIC Power switch ; set to ON Power Input jack
Connections for a typical Dukane projector |
|
Connect the audio cable to MIC port on the projector. |
|
Go to the projector menu and set mic level High; |
|
ADVANCED MENU / AUDIO/ MIC LEVEL / HIGH |
|
Then set the MIC VOLUME to midrange , about 30; |
|
ADVANCED MENU / AUDIO/ MIC VOLUME / Set midrange |
|
For the projector to have the sound system operating when the lamp is off set the Standby |
|
Mode to Normal ; |
|
ADVANCED MENU / STANDBY MODE / NORMAL |
|
Projector speakers ; If using the projector speakers be sure they are turned ON. |
|
Also projector volume needs to be set at a suitable level. | WMIC1_Quick Start Guide Rev 01 |
|