Installation
| ! Before placing your new appliance into operation | |
GB | ||
please read these operating instructions carefully. | ||
| ||
| They contain important information for safe use, for | |
| ||
| installation and for care of the appliance. | |
| ! Please keep these operating instructions for future | |
| reference. Pass them on to possible new owners of | |
| the appliance. |
Positioning
!Keep packaging material out of the reach of children It can become a choking or suffocation hazard. see Precautions and tips).
!The appliance must be installed by a qualified person in compliance with the instructions provided. Incorrect installation may cause harm to persons, animals or may damage property.
Fitting the appliance
Use the appropriate cabinet to ensure that the appliance functions properly.
•the panels adjacent to the oven must be made of
•cabinets with a veneer exterior must be assembled with glues which can withstand temperatures of up to 100°C.
•to install the oven under the counter (see diagram) and in a kitchen unit, the cabinet must have the following dimensions:
Ventilation
To ensure good ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x
560mm (see diagrams).
. | 45 | mm | . |
mm |
| ||
560 |
|
|
|
Centring and fastening
Position the 4 tabs on the side of the oven according to the 4 holes of the outer frame. Adjust the tabs according to the thickness of the cabinet side panel, as shown below:
thickness of 20 mm: take off the removable part of the tab (see diagram);
thickness of 18 mm: use the first groove, which has already been set in the factory (see diagram);
595 mm. | 23 mm. |
567 mm. | |
| 5 mm. |
595 | mm. |
| . |
| 545 | mm | |
|
| ||
| . |
|
|
| mm |
|
|
24 |
|
| |
|
| . |
45 | mm | |
|
| |
| 558 | mm. |
|
| |
593 mm.
thickness of 16 mm: use the second groove (see diagram).
Secure the appliance to the cabinet by opening the
!The appliance must not come into contact with electrical parts once it has been installed.
The consumption indications on the data plate have been calculated for this type of installation.
oven door and putting 4 screws into the 4 holes of the outer frame.
!All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool.
4