Sliding rack kit assembly, Assistance

		Sliding rack kit assembly
	GB	Sliding rack kit assembly
	GB	To assemble the sliding racks:

Assistance

Warning:

The appliance is fitted with an automatic diagnostic

1.Remove the two frames, lifting them away from the spacers A (see figure).

system which detects any malfunctions. Malfunctions are displayed by messages of the following type: “ER” followed by numbers.

Call for technical assistance if a malfunction occurs.

Before calling for Assistance:

•	Check whether you can fix the problem yourself.
•	Restart the programme to check whether the
	malfunction has disappeared.
•	If it has not, contact the Authorised Technical

Left	Right guide
guide rail	rail
B
	C Di
	of rect
	e	i
	x	on
	tract
		i
		on

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

Assistance Service.

Never use the services of an unauthorised technician.

Please have the following information to hand:

• The message shown on the TEMPERATURE
	display.
•	The appliance model (Mod.).
•	The serial number (S/N).

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

The latter two pieces of information can be found on the data plate located on the appliance.

4. Finally, fit the frames on the spacers A.

Do not place the sliding racks in position 5.