Hotpoint GW81 manual Other Notes on Timer Operation

ELECTRONIC CLOCK & AUTOMATIC OVEN

TIMER OPERATION

Minute Cook End

Minder Period Time Manual

A

U

T

O

Minute Cook End

Minder Period Time Manual

TO CANCEL AN AUTO COOKING PROGRAMME BEFORE THE COOK PERIOD HAS FINISHED.

Step 1 Turn the oven control(s) to the OFF position.

Step 2 Press and hold in the “Cook Period” button.

Step 3 With the “Cook Period” button still held in, return the display to 0.00 by pressing the “–” button.

Step 4 Release the “Cook Period” and “–” buttons and the display will revert to the time of day and the “Auto” symbol will flash.

Step 5 Press the “Manual” button to return the oven(s) to “Manual” operation. The “Auto” symbol will go out.

Note 1 When cooking automatically the Cook Period can be checked at any time by simply pressing the Cook Period button.

OTHER NOTES ON TIMER OPERATION

1.When cooking Automatically the Cook Period can be checked at any time simply by pressing the Cook Period button.

2.When cooking Automatically the End Time can be checked at any time by simply pressing the End Time button.

3.Having set a Cook Period and End Time an electronic device stores the information. The device within the timer will switch the oven(s) on and off at the required times.

4.When setting an Auto Cooking Programme and a mistake is made, to clear:–

(a)Press and hold in the “Cook Period” button.

(b)With the Cook Period button still held in, return the display to button.

A

UT by pressing the “–”

O

(c)Release the “Cook Period” & “–” buttons, and the display will revert to the time of day and the “Auto” symbol will flash.

(d)Press & release the “Manual” button.

(e)Start the sequence again.

5.If at any time the display shows three flashing zero’s 0.00. It is likely that the electricity supply to the oven has been interrupted. Reset the timer to the correct time of day.

Food in the oven may, therefore, not have been cooked, before serving check food is thoroughly heated and completely cooked.

6.To set each function always press and hold the required function button and at the same time press “+” or “–” buttons.

Note: Between the hours of 22.00 & 06.00 the display dims to prevent glare.

However, if you should operate a button during this period, the timer will return to normal brightness for a few seconds and then dim again.

11